Vango Hydrogen Pitching Instructions

  • Hello! I've reviewed the user manual for the Vango F10 Project Hydrogen tent. This document explains how to set up and take down the tent, including the use of the pumpsack, a bike pump for inflation, and key peg points. I'm ready to answer any of your questions about this tent and its setup process.
  • How many people are needed to erect this tent?
    Can I inflate the beam with my mouth?
    To what pressure should I inflate the tent?
B.
PITCHING
C.
Vango makes every effort to ensure the accuracy of our information. We do however have a policy of continuous improvement
and we therefore reserve the right to change or amend colours and specifications without prior notice. ©AMG Group Ltd.
F10 Project Hydrogen
NL - Deze tent moet
worden omgeven door
minstens 1 personen
IT - Questa tenda
deve essere eretto da
almeno 1 persone
FR - Cette tente doit
être érigée par au
moins 1 personnes
DE - Dieses Zelt sollte
von mindestens zwei
Personen aufgestellt
werden
CZ - Tento stan by
měl být postaven
nejméně 1 osoby
EN - This tent should
be erected by at least
1 people
3x10
A.
Top up pressure to 6 PSI using
bike pump via Schrader valve.
v. Close door & close zip clip
Peg out using larger pegs for
main peg points 2 at shorter
end, one on central guy at
lower end.
iv.
i.
ii. iii.
i. Insert carbon upright into
pocket on outside of flysheet.
ii. Loosely peg out flysheet.
The pumping action for using
the pump sack:
i. Extend tent bag to double length.
ii. Attach tent bag/ pump sack
end valve to large valve on tube
and inflate tent bag by blowing
into it from a distance.
iii. Compress tent bag as shown.
The pumpsack can be used to inflate the beam quickly using the method described below. Do not inflate
directly with your mouth, moisture from breath can speed the degradation of the TPU inner coating.
The pumpsack can only inflate to a low pressure & a bike pump should be used to get to a firm 6 PSI.
6
ii.
i.
TAKING DOWN & PACKING
B.
A.
C.
D.
Vango makes every effort to ensure the accuracy of our information. We do however have a policy of continuous improvement
and we therefore reserve the right to change or amend colours and specifications without prior notice. ©AMG Group Ltd.
F10 Project Hydrogen
NL - Deze tent moet
worden omgeven door
minstens 1 personen
IT - Questa tenda
deve essere eretto da
almeno 1 persone
FR - Cette tente doit
être érigée par au
moins 1 personnes
DE - Dieses Zelt sollte
von mindestens zwei
Personen aufgestellt
werden
CZ - Tento stan by
měl být postaven
nejméně 1 osoby
EN - This tent should
be erected by at least
1 people
i. Remove pegs.
ii. Remove single upright.
Use valve lid to push open
valve and deflate beam.
Roll beam to remove air from beam.
Fold up flysheet and put
back into the stuff sack.
Deflation
of beam
i. Use valve lid to
push open valve and
deflate beam.
ii. Roll beam to remove
air from beam.
ii.
i.
1
2
1x10
ii.
1/2