ASA Electronics VAVSMOD2BAR Operating instructions

Hello! I've reviewed the instructions for the Voyager VAVSMOD2BAR module. This document provides detailed steps to update the software and calibrate the SKU for the device, including using a USB drive for updates and a remote for calibrations. I am ready to answer any questions you have about how to perform an update and how to calibrate.
What components are needed for updating?

How do I start the software update?

How long does the update take?

How do I enter calibration mode?

VAVSMOD2BAR Logo Software Update and SKU Calibration

Components needed:

IR Receiver and Remote.

Software to be used found here:

S:\Public\Engineering\360 CUSTOMER SOFTWARE\VAVSMOD2BAR

Updating:

1. Load the folder labeled “APP_UPDATE” onto a Thumb Drive.

2. With the desired Software on the USB, insert the USB BEFORE powering on the Module.

3. Power on the Module and the Display will show a White Truck Image, then it will start its Update.

(Update takes about 45 to 60 seconds)

4. Once Updating is completed it will say ‘Update Successful,’ at this point remove and cycle the Power on

the Module.

Calibration for PONTOON BOAT 2 SKU

1. Once the Module is powered on, enter “02580258” using the remote to enter Calibration Mode:

2. Hold the Left Arrow on the Remote to move the Cursor to the SKU Option:

3. Press OK on the Remote to change the SKU to PONTOON BOAT 2:

4. Arrow Down to the Width and change to 320, Arrow down the Length and change to 1090.

5. Arrow down to Save & Next and press OK on the Remote

6. Scroll through the Images using the Down Button to confirm Maps are in the proper place:

7. Press the Right Button to Next and the Press OK and then highlight Yes.

8. The system will then start its Calibration. The Bubbles will change from Red to Green.

9. Once completed, the Module will reboot and the 360 Image will look like the image below:

10. At this point, the Calibration is complete.