3
English
Our products are designed to meet the
highest standards of quality, functionality
and design. We hope you enjoy your new
Braun Shaver.
Batteries
Two 1,5 volt batteries.
For best performance, use alkaline
manganese batteries (type LR 6, AM 3,
MN 1500 or size AA alkaline, e. g.
Duracell
®
).
These batteries provide a shaving
capacity of approx. 60 minutes.
To open the battery compartment, turn
the battery cover (7) 90° in the direction
of the arrow, then pull off the battery
cover.
Insert batteries with the poles in the
direction marked. Before closing the
battery compartment, make sure the
cover is dry and clean.
Note: Never leave batteries in the shaver
for long periods of time when the shaver
is not in use (danger of leakage). Take
empty batteries out of the shaver
immediately.
To protect the environment,
dispose of empty batteries at your
retail store or at appropriate
collection sites according to
national or local regulations.
Shaving
Press the on switch (5) to operate the
shaver.
Model 120 only: To trim sideburns,
moustache or beard, slide the long hair
trimmer (4) upwards.
Tips for the perfect shave
For best shaving results, Braun
recommends you to follow 3 simple
steps:
1. Always shave before washing your
face.
2. At all times, hold the shaver at right
angles (90°) to your skin.
3. Stretch your skin and shave against
the direction of your beard growth.
Cleaning
The shaver head is suitable for
cleaning under running tap water.
Regular cleaning ensures better shaving
performance. Rinsing the shaving head
under running water after each shave is
an easy and fast way to keep it clean (A):
Switch the shaver on and rinse the
shaver head under hot running water.
You may use liquid soap without
abrasive substances. Rinse off all foam
and let the shaver run for a few more
seconds.
Next, switch off the shaver, remove the
shaver foil (2) and cutter block (3).
Then leave the disassembled shaving
parts to dry.
If you regularly clean the shaver under
water, then once a week apply a drop
of light machine oil onto the long hair
trimmer and shaver foil.
Alternatively, you may clean the shaver
using the brush provided (B):
Switch off the shaver. Remove the
shaver foil and tap it out on a fl at
surface.
Using the brush, clean the cutter block
and the inner area of the shaver head.
However, do not clean the shaver foil
with the brush as this will damage the
foil.
•
•
•
•
•
5682423_NE120_AP.indd 35682423_NE120_AP.indd 3 20.11.2007 11:22:07 Uhr20.11.2007 11:22:07 Uhr