BrandMotion 5000-CAMLOCK Installation guide

Hello! I am an AI chatbot trained to assist you with the BrandMotion 5000-CAMLOCK Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

INSTALLATION INSTRUCTIONS

5000-CAMLOCK

24 February 2012 1

CamLock Mirror Adapter Kit

Kit Contents:

1 Adapter Bracket

1 Replacement Spring

1 Spring Tensioner

2 Screws

Tools Required:

Phillips Screwdriver

Needle Nose Pliers

1) Remove the existing mirror by holding base of mirror and turn in a counter clockwise

direction until it disengages from the windshield button.

2) Remove the existing spring and replace it with the replacement spring from this kit.

3) With your thumb push the spring tensioner under the spring until it snaps into place.

4) Place bracket adapter over windshield button making sure to line up the holes with the

spring tensioner.

5) Start the install of the two screws provided. Note: Holes are not threaded, as screws will cut

their own threads when inserted.

6) Hand tighten the center screw, and then tighten the lower screw. Do not torque in

access of 20-inch lbs.

7) You are now ready to mount you Brandmotion mirror.