Goal Zero 30 Amp External MPPT Kit User guide

Goal Zero
Brand
Goal Zero
Model
30 Amp External MPPT Kit
Type
User guide

This manual is also suitable for

EXTERNAL
MPPT
INSTALL INSTRUCTIONS
Mount your Victron MPPT near your Yeti Tank or
external 12V lead-acid battery. The MPPT to Tank
cable is only 6’ long, so you will need to mount the
MPPT within a 6’ radius of your last Tank.
Connect the two cables as shown in the picture.
a. Connect the MPPT to Tank cable to the
“Battery” Terminals of the Victron MPPT with the
red end positive (+) and the black end negative (-).
b. Connect the MPPT to Solar cable to the “PV”
Terminals of the Victron MPPT with the red end
positive (+) and the black end negative (-).
Connect the battery cable from your Victron
MPPT to your Lead-Acid battery. This will allow
power to flow to the MPPT.
Connect your solar panels to the MPPT using
the MPPT to Solar cable.
If you have any additional questions about this
installation please reach out to our solutions center
representatives at 1-888-794-6250 or email us at
support@goalzero.com.
*Please note this system is programmed and designed
to be used with Goal Zero Tank Batteries and Goal Zero
solar panels. Using different batteries or solar panels is
not advised and could result in serious injury.
MPPT to Tank Cable MPPT to Solar Cable
EXTERNAL MPPT
STEP 1
STEP 2
STEP 3
STEP 4
  • Page 1 1
  • Page 2 2

Goal Zero 30 Amp External MPPT Kit User guide

Goal Zero
Brand
Goal Zero
Model
30 Amp External MPPT Kit
Type
User guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents