Your new TV Monitor/Receiver features a solid
state chassis that is designed to give you many
years of enjoyment. It was thoroughly tested and
tuned at thefactory for best pedormance.
Customer Record
The model and serial number of this product may
be found on the back of the unit. You shouldnote
the model and sedal numberin the space provided
and retain as a permanent record of your
purchase. This willaid in identificationinthe event
of theftor loss.
Productregistrationisavailablefor U.S.customersat:
www.prodreg.oom/panasonlc
Model
Number
Serial
Number
Care
and Cleaning
Screen (Turn TV Off)
Use a mild soap solution or window
cleaner with a softclean cloth. DO NOT
USE ABRASIVE CLEANERS.
Avoid excessive moisture and wipe dry.
Cabinet and Remote Control
Use a softcloth dampened withwater or
a mild detergent solution. Do not use
benzene, thinner, or other petroleum
based cleaners.
Wipe dry with a soft clean cloth. Avoid
excessivemoisture.
Specifications
Power Source
CT-I 3R4 CT-20G24
CT-13R30 CT-20G34 120V AC,
CT-13R40 CT-20R16 60Hz _
CT-2_4 CT-2013S
CT-20G14
VHF.12;
Channel Capability - 181 UHF-56;
Cable-113
1V ,
Video Input Jacks 75 _o_p_,
(some models) PhonoJack
Type
Audio Input Jacks 500mV RMS
(somemodels) 47K Ohm
To Audio AMP Jack 0-2,0V RMS
(somemodels) 4.7K Ohm
Specificationsare subject to change withoutnotice
or obligation.
Television Location
This unit is intended to be used with an optiona
stand or entertainmentcenter. Consult yourdeale=
for available options.
[] Avoid excessive sunlight or bright lights
includingreflections.
C3 Keep away from excessive heat or moisture
Inadequate ventilation may cause interna
componentfailure.
[] Fluorescent lighting may reduce Remote
Controltransmittingrange.
[] Avoid magnetic equipment, includingmotors
fans, or external speakers.
Optional Cable Connections
Shielded audio and video cables should be use(
between components. For best results:
Use75-ohro co_yJ_atshielded cabtes.
• . Use appropriate input and output
connectorsthat match your component
connectors,
Avoid long cables to minimize
interference.
AC Power Supply Cord
CAUTION: TO PREVENT
ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO
WIDE SLOT OF AC OUTLET Potadzedplug
AND FULLY INSERT. DO
NOT USE A PLUG WITH A
RECEPTACLE OR OTHER Non-Polarizedplug
OUTLET UNLESS THE
BLADE CAN BE FULLY INSERTED TO PREVENT
BLADE EXPOSURE, FOR SOME MODELS THAi"
ARE NON-POLARIZED, THE USE OF AN AC
ADAPTOR CONNECTOR MAY BE NECESSARY.
Batteries
Replace batteries inpairs.
Do not mix battery types (zinc carbon
withalkaline).
Do not recharge, shod-cimuit,
disassemble, heat, or bum use€
battedes.
Cable / Antenna
For proper reception, either a cable or antenna
connectLonare required.
Cable Connection
Connect the cable supplied by your local
cable company.
Incoming Cable from Cable Company
75OhmsVHFAJHF
onbackofTV
Note:
A cable converterbox may be required
for proper reception. Check with your
local Cable company for compatibility
requirements.
-2-