2. SCE
  3. SCE-HWK1014

SCE SCE-HWK1014 Installation Information

  • Hello! I've reviewed the installation instructions for the Saginaw Control ELJ Hinged Window Enclosures. This document outlines the dimensions, mounting details, and strip gasket application process for various models like SCE-HWK1014, SCE-HWK1014SS and others. I'm ready to answer your questions about these enclosures.
  • What is the purpose of the strip gasket?
    Where should the strip gasket be applied?
    What should I do if the height of enclosure is less or equal than 12.00 ?
spec-elj-hwk-instman.pdf
1
Bottom View
Front View
Front View
(Door removed)
Rear View
ELJ HINGED WINDOW ENCLOSURE
2.63
3.375
3.13
C
Door
C
Door
L
L
H
H - 4.00
W - 4.625
W
Opening
W - .875
Opening
H - .875
.75 1.50
Catalog Number Height Width
SCE-HWK1014 10 14
SCE-HWK1014SS 10 14
SCE-HWK1212 12 12
SCE-HWK1212LG 12 12
SCE-HWK1212SS 12 12
SCE-HWK1216 12 16
SCE-HWK1216SS 12 16
SCE-HWK1312 13 12
SCE-HWK1418 14 18
SCE-HWK1418SS 14 18
SCE-HWK1620 16 20
SCE-HWK1620SS 16 20
SCE-HWK1814 18 14
SCE-HWK1814LG 18 14
SCE-HWK1814SS 18 14
SCE-HWK2218 22 18
SCE-HWK2218LG 22 18
SCE-HWK2218SS 22 18
(W-1.50)/2
.750
typ.
1.00
typ.
1.00
typ.
Rear Opening
W - 2.00
Rear
Opening
H - 2.00
(H-1.50)/2
.75
typ.
Omit hole if
W <= 12.00
Omit hole if
H <= 12.00
If H <= 14.00 (1)
latch used centered
vertically if H > 14.00
latches used
Ø.218
typ. Strip gasket
ships loose
2.00
Ø.44 for SCE-BVKD
breather vent/drain
spec-elj-hwk-instman.pdf
2
A. Apply strip gasket provided with bolt pack to the exterior back of the enclosure.
B. Start applying the strip gasket centered at the bottom of the enclosure.
C. The strip gasket needs to be applied in one continuous path, on the outside of each mounting hole.
D. End with the strip gasket seam centered at bottom of the enclosure, flush to the starting point.
Exterior back
of enclosure
Strip gasket seam
Mounting hole
/