VESA Compatible Desk Mount
with Printer Shelf Compartment
PAD-PARAFPDM
INSTRUCTION - MANUAL
CONTENTS:
INSTALLATION:
888-733-4448
1. Assembling base
1A. Connect base (B) with body (A). Take
the body (A) and align the mounting holes. Rotate in (4) screws
(G) with provided allen key (H) until securely tightened.
2. Attaching Base Pads
2A. Flip over the now combined base section. Find the base pads
(component I) and peel off the sticker to expose the adhesive. Place the
foam pads (adhesive face down on base) at the corners and give it a firm
press for a few seconds until it’s securely attached.
How To Attach a
VESA Compatible Device
H
G
B
A
I
(x4)
(X4)
When attaching a CTA paragon enclosure, rotate in from the front (4)
screws (E) using the provided allen key tool (H) while holding hex
nuts from behind with your hand. Keep rotating until securely tightened.
When attaching a monitor or other VESA compatible item, rotate in (4)
screws (E) from behind until securely tightened using
provided allen key tool (H).
**Monitor NOT
included and for
example purposes only
x1
A
x1
B
x1
C
M5x12
x4
E
M5 Hex Nut
x4
F
M5 x 6
x4
G
M5 Allen Key
x1
H
x4
I
x4
F
E
J
H
H
(x4)
E
x2
N
x1
K
Foam Adapter & Sheet Bundle
x1
J
888-733-4448
How To Cable Route &
Storage Manage
** Cables
not included and shown for
Unlock all back compartment using keys (C). Fish wire through the top to connect with device and out
the bottom to your outlet or desired power source. Close door, insert key and rotate counterclockwise to lock.
exampe purposes only.
C
How to Setup Device in Enclosure
Lock or unlock your tablet enclosure (J) with security key as shown.
Find the appropriate size foam padding (K) for the tablet you wish to
use. Make sure device is compatible for the enclosure. Lay in device and
connect any cables/cords as needed.
If needed, lay-in correct included masking insert (K). Close and lock enclosure
afterwards and you’re set
**Tablet shown for
illustration and
NOT INCLUDED.
**Tablet shown for
illustration and
NOT INCLUDED.
J
J
K
K
/