Eurolux F44 Owner's manual

Eurolux
Brand
Eurolux
Model
F44
Type
Owner's manual

This manual is also suitable for

Square Extractor Fan
F43 / F44 / F45
PRODUCT CODE
ILLUSTRATIONS:
Motor
Black Fuse
Red
Terminal
Yeller/green Grounding
Power
Power
Yellow/Green
Terminal
Fuse
Black
Red
Ground
Motor
Please read instructions before commencing installation and retain for future reference.
Cape Town - 9 Racecourse Road, Milnerton, 7441
Johannesburg - 10 Milkyway Avenue, Linbro Business Park, Sandton, 2065
www.eurolux.co.za
ENVIRONMENTAL PROTECTION
Waste electrical & Electronic equipment regulations requires that any of our products
showing this marking must not be disposed of with other household or commercial
waste. To prevent possible harm to the environment or human health from uncontrolled
waste disposal, please separate any such products from other waste types and recycle
it responsibly at your local facilities.
Cut out
is round
80mm
125mm
158mm
F43 / F44 / F45 attachments:
If the external exible cable or cord of this fan is damaged, it should be exclusively replaced by the
manufacturer or his service agent or a similar qualied person in order to avoid a hazard.
To ensure that you get maximum longevity and maximum use out of your fan, please observe the
following safety instructions.
Electrical products can cause death, injury, or damage to property. Installation of the fan must be
carried out by a qualied electrician, in accordance with SANS 10142. On completion of installation,
ensure that the Certicate of Compliance is updated.
• Before connecting this fan, ensure that voltage indicated on the rating label corresponds with the mains
voltage in your home.
• When cleaning, ensure that the power is turned off.
• This fan is checked in full for conformity to the quality standards and safety requirements.
• The manufacturer / supplier is not responsible for any damage of properties and persons, caused by
the incorrect use or installation of the fan.
• Should you be unsure of how to install this fan correctly, please consult a professional electrician or
your supplier for assistance.
• Ensure all items / components, threads and screws are tightly secured.
IMPORTANT:
• Tampering with this fan, i.e.using silicon sealers or incorrect cabling, will invalidate your warranty.
If one is not supplied within the carton, DO NOT use a solid speed control.
• Please check whether the connection of the power cord is safe and reliable before installation.
• Always ensure that the mains supply voltage is correct.
• Do not use the fan outdoors, in wet conditions.
• Do not insert objects or ngers through the bars of the grill.
• This appliance is not intended for use by young children or inrm persons unless they have been
adequately supervised by a responsible person.
• Always unplug the fan when cleaning or moving from one location to another.
• Always ensure that the fan is on an even, stable surface.
IMPORTANT SAFEGUARDS
Connect the blue/brown wires to the L and N position of the socket, and connect the green/yellow wires
to the lamp body where the earth symbol is placed.
Check for any hidden timbers, wiring or water pipes in the cut-out area before installation.
Always ensure that the electricity is turned off before installing.
In order for the warranty to be honoured, the fan must be installed:
1.1. At least 2.3m above the ground.
1.2. At least 90cm away from any hotplate and have at least 50cm clear space above the fan blades.
1.3. Ensure the power cord will not make contact or obstruct the fan blades.
1.4. Ensure any ceiling insulation or frame does not obstruct airow to the fan.
1.5. Clean the grill and blades regularly
1.6. If ducting is required, it must be larger than the diameter of the fan blades.
Ducting that is longer than 1meter will affect the fans performance and void the warranty.
1. Cut a hole of according to cut-out using either a jigsaw, keyhole saw or hacksaw.
2. Remove the grill (pulls free of the frame) and connect the power to the outlet.
Insert the fan assembly into the opening.
A: Use wood screws (not supplied) to secure the fan to the ceiling.
Locate screws in the 3 holes in the outer lip of the fan frame.
3. Place the grill over the fan assembly and push up until it snaps into place.
4. Precautions must be taken to avoid the back-ow of grease into the room from an open ow of
gas of any other open-re appliances.
INSTALLATION:
• Fitting material: Plastic.
• Motor: F43 - 15W
F44 - 25W
F45 - 25W
• Voltage: 220 - 240V~ 50/60Hz.
• Protection against electric shock: Class 2.
• IP: X4
• Not for outdoor use.
• Dimensions: F43 - (H)160mm x (W)160mm x (D)80mm.
F44 - (H)172mm x (W)172mm x (D)85mm
F45 - (H)210mm x (W)210mm x (D)85mm
• Cut-out: F43 - 125mm.
F44 - 145mm
F45 - 184mm
• Air movement: F43 - 100m3/h
F44 - 162m3/h
F45 - 210m3/h
SPECIFICATIONS • This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
CLEANING
• Before cleaning always ensure the power supply is turned off and that the fan has been unplugged.
• Do not immerse the fan in water.
• No abrasive products, solvents, detergent may be used to clean this fan.
• Ensure that the fan does not come in contact with corrosive chemicals, etc.
• The motor bearings are permanently sealed and do not require additional lubrication.
Aside from the grill and blades, there are no user serviceable parts in this appliance.
Do not tamper with the fan motor, if repair is required, contact the dealer where you purchased
this appliance or contact Eurolux.
  • Page 1 1
  • Page 2 2

Eurolux F44 Owner's manual

Eurolux
Brand
Eurolux
Model
F44
Type
Owner's manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents