AcuRite 00568SBL User manual
- Category
- Weather stations
- Type
- User manual
This manual is also suitable for
Instruction Manual
SAVE THIS MANUAL FOR FUTURE REFERENCE.
Questions? Contact Customer Support at
(877) 221-1252 or visit www.AcuRite.com.
CONTENTS
Unpacking Instructions ........... 2
Package Contents .................. 2
Product Registration ............... 2
Features & Benets ................. 3
Setup .................................... 4
Temperature Units .................. 4
Placement Guidelines ............. 5
Troubleshooting ..................... 6
Specications ......................... 6
FCC Information .................... 6
Customer Support .................. 7
Warranty............................... 7
Thermometer with Wired Sensor
2
Congratulations on your new AcuRite product. To ensure the best
possible product performance, please read this manual in its entirety
and retain it for future reference.
Unpacking Instructions
Remove the protective lm that is applied to the LCD screen prior to using this
product. Locate the tab and peel off to remove.
Package Contents
1. Display unit with tabletop stand
2. Wired temperature sensor
3. Instruction Manual
PRODUCT REGISTRATION
Register online
to receive 1 year
warranty protection
www.AcuRite.com
IMPORTANT
PRODUCT MUST BE REGISTERED
TO RECEIVE WARRANTY SERVICE
►
Register a Product
3
Features & Benets
FRONT
1. Low Battery Icon
2. Timespan for Records
Indicates records are being displayed for
either the past 24 hours or all-time.
3. MIN Indicator
Indicates low temperature record or low
humidity record is being displayed.
4. Removable Tabletop Stand
5. SELECT Button
Press to manually cycle through current
readings and records.
6. Wired Sensor Retention Slot
For cord management.
7. Wired Temperature Sensor with
Adhesive Pad
8. MAX Indicator
Indicates high temperature record or high
humidity record is being displayed.
9. Auto-Cycle Icon
Indicates auto-cycle mode is active.
1
2
4
3
5 6
7
9
10
12
13
17
15
16
18
14
8
11
10. Current Temperature or Humidity
Arrow icon indicates direction temperature or
humidity is trending.
11. °F or % Icons
Indicates either temperature or relative
humidity is being displayed.
12. INDOOR/OUTDOOR Indicator
Indicates viewing readings for INDOOR
(display) or OUTDOOR (sensor).
13. Wired Sensor Storage
Secure excess wire and the wired sensor.
BACK
14. Battery Compartment Cover
15. °F/°C Button
Select temperature units.
16. Battery Compartment
17. Integrated Magnets
For magent-mountable placement.
18. Integrated Hang Hole
For easy wall mounting.
4
Install or Replace Battery
AcuRite recommends high quality
alkaline batteries for the best
product performance. Heavy duty
or rechargeable batteries are not
recommended.
Slide the battery compartment
cover open and install 1 fresh
“AAA” battery. Follow the polarity
(+/-) diagram in the battery
compartment.
Replace battery cover.
Select Temperature Units
To select between degrees Fahrenheit (°F) or Celsius (°C) temperature units,
slide the “°F/ °C” switch, located inside the battery compartment on the back
of the display.
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to
be used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of
used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries
in re, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT
recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.
SETUP
1
2
OPERATION
1
2
Display Modes
MANUAL: By default, the unit is in MANUAL mode. During Manual Mode,
press and release the “SELECT” button, located on the front of the display, to
manually cycle through readings and records.
AUTO CYCLE: In AUTO-CYCLE mode, the display will automatically cycle
through current readings for INDOOR (display) and OUTDOOR (sensor)
temperature and humidity. Each reading will be displayed for 5 seconds.
Press and HOLD the “SELECT” button on the front of the display for 5 seconds
to enter AUTO-CYCLE mode. The icon will appear on the display.
To exit AUTO-CYCLE mode, press and HOLD the “SELECT” button for 5
seconds. The icon will disappear from the display.
5
Placement for Maximum Accuracy
AcuRite sensors are sensitive to surrounding environmental conditions. Proper
placement of both the display and wired temperature sensor are critical to the
accuracy and performance of this product.
Place the display in a dry area free of dirt and dust. Display stands upright for
tabletop use, is wall-mountable or magnet-mountable.
To observe outdoor temperatures, the wired sensor must be placed outside. The
sensor can be securely mounted by using the adhesive pad or the integrated
hang hole. Take care not to damage the wired sensor during mounting.
Important Placement Guidelines
• To ensure accurate temperature measurement, place display and wired
sensor out of direct sunlight and away from heat sources or vents.
• The wired temperature sensor is not waterproof and is not intended for
permanent submersion in liquids. Submersion in liquid for more than 30
seconds may result in failure of the wired sensor.
High & Low Records
High and low records are displayed for INDOOR (display) temperature and
humidity and OUTDOOR (sensor) temperature. High and low records are
available from the past 24 hour time period or over all-time.
All-time high and low records reect the minimum and maximum readings since
the unit was powered on, since the batteries were changed, or since the unit
was manually reset – whichever event was the most recent.
During Manual Mode (page 4), you can cycle through readings and high/low
records by pressing the “SELECT” button. Data is displayed in the following order:
CURRENT TEMPERATURE - OUTDOOR (sensor)
CURRENT TEMPERATURE - INDOOR (display)
CURRENT HUMIDITY - INDOOR (display)
24-HOUR LOW TEMPERATURE - OUTDOOR (sensor)
24-HOUR LOW TEMPERATURE - INDOOR (display)
24-HOUR LOW HUMIDITY - INDOOR (display)
24-HOUR HIGH TEMPERATURE - OUTDOOR (sensor)
24-HOUR HIGH TEMPERATURE - INDOOR (display)
24-HOUR HIGH HUMIDITY - INDOOR (display)
ALL-TIME LOW TEMPERATURE - OUTDOOR (sensor)
ALL-TIME LOW TEMPERATURE - INDOOR (display)
ALL-TIME LOW HUMIDITY - INDOOR (display)
ALL-TIME HIGH TEMPERATURE - OUTDOOR (sensor)
ALL-TIME HIGH TEMPERATURE - INDOOR (display)
ALL-TIME HIGH HUMIDITY - INDOOR (display)
To manually reset any record, rst view the record, then press and HOLD
the “°F/°C” button, located inside the battery compartment, for 5 seconds.
Dashes display to conrm the record has been cleared.
6
Troubleshooting
Inaccurate
temperature
• Make sure both the display unit and wired
temperature sensor are placed out of direct sunlight
and away from any heat sources or vents.
Display screen
not working
• Check that the battery is installed correctly. Battery
may need to be replaced.
Specications
TEMPERATURE RANGE
Display: 32°F to 122°F; 0°C to 50°C
Wired Sensor: -58°F to 158°F; -40°C to 70°C
HUMIDITY RANGE
Display: 10% – 99% RH (relative humidity)
POWER
1 x AAA alkaline battery
FCC Information
This device complies with part 15 of FCC rules. Operation is subject to the following two conditions:
1- This device may NOT cause harmful interference, and
2- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modications to this equipment.
Such modications could void the user authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation of the device.
7
Customer Support
AcuRite customer support is committed to providing you with best-in-
class service. For assistance, please have the model number of this
product available and contact us in any of the following ways:
(877) 221-1252 info@chaney-inst.com
24/7 support at www.AcuRite.com
► Installation Videos ► Register your Product
► Instruction Manuals ► Support User Forum
► Replacement Parts ► Submit Feedback & Ideas
PRODUCT REGISTRATION
Register online
to receive 1 year
warranty protection
www.AcuRite.com
IMPORTANT
PRODUCT MUST BE REGISTERED
TO RECEIVE WARRANTY SERVICE
►
Register a Product
Limited One Year Warranty
At AcuRite, we proudly uphold our commitment
to quality technology. Chaney Instrument Co.
warrants that all products it manufactures to
be of good material and workmanship, and to
be free of defects when properly installed and
operated for a period of one year from the date
of purchase.
We recommend that you visit us at www.AcuRite.
com for the fastest way to register your product.
However, product registration does not eliminate
the need to retain your original proof of
purchase in order to obtain warranty benets.
Chaney Instrument Co. warrants that all products it manufactures
to be of good material and workmanship, and to be free of
defects when properly installed and operated for a period of
one year from the date of purchase. Remedy for breach of this
warranty is limited to repair or replacement of the defective
item(s). Any product which, under normal use and service, is
proven to breach the warranty contained herein within ONE
YEAR from date of sale will, upon examination by Chaney,
and at its sole option, be repaired or replaced by Chaney.
Transportation costs and charges for returned goods shall
be paid for by the purchaser. Chaney hereby disclaims all
responsibility for such transportation costs and charges. This
warranty will not be breached, and Chaney will give no credit
for products it manufactures which have received normal wear
and tear, been damaged (including by acts of nature), tampered,
abused, improperly installed, damaged in shipping, or repaired
or altered by others than authorized representatives of Chaney.
The above-described warranty is expressly in lieu of all other
warranties, express or implied, and all other warranties are
hereby expressly disclaimed, including without limitation the
implied warranty of merchantability and the implied warranty
of tness for a particular purpose. Chaney expressly disclaims
all liability for special, consequential or incidental damages,
whether arising in tort or by contract from any breach of this
warranty. Some states do not allow the exclusion or limitation
of incidental or consequential damages, so the above limitation
or exclusion may not apply to you. Chaney further disclaims all
liability from personal injury relating to its products to the extent
permitted by law. By acceptance of any of Chaney’s products,
the purchaser assumes all liability for the consequences arising
from their use or misuse. No person, rm or corporation is
authorized to assume for Chaney any other liability in connection
with the sale of its products. Furthermore, no person, rm or
corporation is authorized to modify or waive the terms of this
paragraph, and the preceding paragraph, unless done in writing
and signed by a duly authorized agent of Chaney. This warranty
gives you specic legal rights, and you may also have other
rights which vary from state to state.
For in-warranty claims: Chaney Instrument Co.
965 Wells St., Lake Geneva, WI 53147
©Chaney Instrument Co. All rights reserved. AcuRite is a registered trademark of
the Chaney Instrument Co., Lake Geneva, WI 53147. All other trademarks and copy-
rights are the property of their respective owners. AcuRite uses patented technology.
Visit www.AcuRite.com/patents for details.
Printed in China
02042 INST 011615
It’s More than Accurate, it’s
AcuRite offers an extensive assortment of precision instruments,
designed to provide you with information you can depend on to
Plan your day with condence
™
.
www.AcuRite.com
Weather
Stations
Temperature
& Humidity
Weather
Alert Radio
Kitchen
Thermometers
& Timers
Clocks
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
AcuRite 00568SBL User manual
- Category
- Weather stations
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
AcuRite 02042 Installation guide
-
AcuRite Pierson Wall Clock User manual
-
AcuRite Digital Monitor User manual
-
-
-
-
-
-
-