Allied Brass CV-1TBT-22-GAL-UNL Installation guide

Step1: Drill Holes in Wall for screws or screw anchors and attached Mounting plate to Wall

Determine your desired location for installation and make a mark for the location of the mounting plate and CARD-58 CAP.

Remove mounting plate from backplate by loosening set screw in backplate as pictured below. Place center hole of mounting

plate over mark made above. Make 2 marks where mounting screws will be placed as shown below. Drill hole at each of the

mark. (You may substitute other style mounting anchors or screws if desired). Place anchors into the holes made. Place

mounting plate over holes and secure to mounting surface using screws as shown below.

No portion of this document or any artwork contained herein should reproduced in any way without the written consent of ALLIED BRASS INC.

INSTALLATION INSTRUCTIONS

CV-1TBT-22-GAL

MOUNTING PLATE

DRILLED HOLES

PERSPECTIVE

BACKPLATE

SET SCREW

MOUNTING PLATE

SCREW

WALL ANCHOR

DRILLED HOLE

DETAIL A

Step1: Attach Bracket to Mounting Plate

Place bracket on mounting plate and secure by tightening set screw as shown below.

No portion of this document or any artwork contained herein should reproduced in any way without the written consent of ALLIED BRASS INC.

INSTALLATION INSTRUCTIONS

CV-1TBT-22-GAL

PERSPECTIVE

DETAIL D

BACKPLATE

MOUNTING PLATE

SET SCREW