CPS-SSI-4P Product Guide
CONTEC CO., LTD. March 2017 Edition
3-9-31, Himesato, Nishiyodogawa-ku, Osaka 555-0025, Japan
Japanese http://www.contec.co.jp/
English http://www.contec.com/ NA04430 (LYTD442)
Chinese http://www.contec.com.cn/ 03242017_rev2 [09092015]
No part of this document may be copied or reproduced in any form by any means without prior written
consent of CONTEC CO., LTD.
- Be sure to connect the product to the stipulated power supply voltage. Connecting to a different voltage might cause a fire
or electrical shock.
- If the equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment may be
impaired.
- This product is not intended for usage in aerospace, space, nuclear power, medical equipment, or other applications that
require a very high level of reliability. Do not use the product in such applications.
- If using this product in applications where safety is critical such as in railways, automotive, or disaster prevention or
security systems, please consult your retailer.
- Do not use or store the product in a location exposed to extremely high or low temperature or susceptible to a rapid
temperature change. Example: - Exposure to direct sun - In the vicinity of a heat source
- Do not use this product in extremely humid or dusty locations. It is extremely dangerous to use this product with its
interior penetrated by water or any other fluid or conductive dust. If this product must be used in such an environment,
install it on a dust-proof control panel, for example.
- Avoid using or storing this product in locations subject to shock or vibration.
- Avoid transporting this products state to shock or vibration that exceeds range of specification.
Impact resistance: 10G (11ms) below
- Use the product in the specified operating condition (temperature, humidity, vibration and shock)
- Please adjust the air current to prevent the reject heat from the product staying around the product.
- Do not use this product in the vicinity of devices that generate strong magnetic force or noise. Such products will cause
this product to malfunction (stop or reboot).
- Do not use or store this product in the presence of chemicals.
- When attaching or detaching a connector or a cable, please be sure that the power cable of controller for the system is
unplugged from the outlet.
- Do not modify this product. CONTEC will bear no responsibility for any problems, etc., resulting from modifying this
product.
- In the event of failure or abnormality (foul smells or excessive heat generation), unplug the power cable of controller
immediately and contact your retailer.
- To connect with peripherals, use a grounded, shielded cable.
- To clean this product, wipe it gently with a soft cloth dampened with either water or mild detergent. Do not use chemicals
or a volatile solvent, such as benzene or thinner, to prevent pealing or discoloration of the paint.
- Do not insert the connector with the incorrect orientation. Also, do not apply excessive force when inserting the
connector. Doing so may damage the product.
- Do not touch this product's terminals with your hands. Otherwise, this may malfunction, overheat, or cause a failure.
- To avoid electrocution do not use the product and connector with a wet hand.
- The specifications of this product are subject to change without notice for enhancement and quality improvement. Even
when using this product continuously, be sure to read the manual and understand the contents.
- If you want to use in places where the influence of the overcurrent or overvoltage is, please select appropriate surge
protection device for all of the route such as signal line.
- Regardless of the foregoing statements, CONTEC is not liable for any damages whatsoever (including damages for loss of
business profits) arising out of the use or inability to use this CONTEC product or the information contained herein.
- When disposing of the product, follow the disposal procedures stipulated under the relevant laws and municipal
ordinances.
- Always attach the end cover while power is active (the cover comes with the configurable type controller).