MD Sports SG040Y20001 User manual

Brand: MD Sports

Model: SG040Y20001

Category: Skill games

Type: User manual

Assembly Instructions

MODEL

SG040Y20001

Menards

www.medalsports.com877-472-4296

- Not Included

RECOMMENDED

Power Tools: Set to Low Torque

High Torque: Over Tightened

Phillips Screwdriver

Electric Screwdrivers may be helpful during assembly; however, please set a low torque and

use extreme caution.

This product is intended for INDOOR use only.

Adult supervision is required for children playing this game.

IMPORTANT NOTICE!

Do not use or keep

product outdoors. For

indoor use only. No

wet/humid conditions.

Keep away from pets in

assembly area

No children in assembly

area

English

TOOLS REQUIRED

SG040Y20001 1(Continued on the next page) www.medalsports.com

ADULT ASSEMBLY REQUIRED.

CHOKING HAZARD - THIS ITEM CONTAINS SMALL PARTS. NOT SUITABLE FOR CHILDREN UNDER 3 YEARS.

DO NOT MODIFY THE PRODUCTS IN ANY WAY.

DO NOT AIM AT EYES OR FACE.

DO NOT POINT THE BLASTER AT PEOPLE OR ANIMALS.

THIS PRODUCT MAY BE MISTAKEN FOR AN ACTUAL FIREARM BY LAW ENFORCEMENT OFFICERS AND OTHERS.

ALTERING STATE OR FEDERAL REQUIRED MARKINGS OR COLORATION IN ORDER TO MAKE THE PRODUCT APPEAR

MORE REALISTIC AND/OR BRANDISHING OR DISPLAYING THE PRODUCT IN PUBLIC IS DANGEROUS AND MAY BE A

CRIME. DISPLAYING, EXHIBITING OR BRANDISHING IN A THREATENING MANNER AND POSSESSION, STORAGE OR

KEEPING ON SCHOOL PROPERTY ARE PROHIBITED ACTIVITIES. THE CRIMINAL PENALTIES MAY BE IMPRISONMENT

AND/OR FINES.

WARNING

FOR FIG. 2 FOR FIG. 2

Mainframe

FOR FIG. 1

PART NUMBER FIG. NUMBER

QUANTITY

PART

PART NAME

English

PARTS IDENTIFIER

SG040Y20001 2(Continued on the next page) www.medalsports.com

Find a clean, level place to begin the assembly of your product.

Verify that you have all listed parts as shown on the part list pages.

BEFORE ASSEMBLY

Blaster

ACCESSORIES

x10

Dart

Bolt

HARDWARE

FOR FIG. 2

ON/OFF

START

PLAYER

PLAYER 1 TIME PLAYER 2

FOR FIG. 3 FOR FIG. 3

Target - A

PRE-INSTALLED PARTS

Target - B

FOR FIG. 3

Target - C

Hanger

FOR FIG. 2

Target Board

FOR FIG. 1

ASSEMBLY

SG040Y20001 www.medalsports.com3(Continued on the next page)

English

FIG. 1

FIG. 2

x10

ON/OFF

START

PLAYER

PLAYER 1 TIME PLAYER 2

Phillips Screwdriver

- Not Included

Back View

ASSEMBLY

SG040Y20001 www.medalsports.com4(Continued on the next page)

English

FIG. 3

Pre-installed

Door

Spring Lock

Note: Hang the Skeet Shooting set on

the door, press the spring lock and pull

the support of the Hanger (2) to adjust

the height as shown in FIG. 3.

ON/OFF

START

PLAYER

PLAYER 1 TIME PLAYER 2

GAME DESCRIPTIONS

Press “ON/OFF START” to turn the game on. The LED will display “2P”. Press “PLAYER” to choose between 1 or 2 players.

In the 2 Player mode, after pressing “ON/OFF START” the LED will display a 5 second countdown. The indicator light will

show against PLAYER 1 and the target will move into position. After the sound ﬁnishes, the LED will countdown from 60

seconds. Each time the target is shot successfully, a sound is heard. PLAYER 1’s turn ends after the target has been shot 3

times, or the 60 seconds have elapsed.

For PLAYER 2’s turn, the LED will display a 5 second countdown. The indicator light will show against PLAYER 2 and the

target will move into position. After the sound ﬁnishes, the LED will countdown from 60 seconds. Each time the target is

shot successfully, a sound is heard. PLAYER 2’s turn ends after the target has been shot 3 times, or the 60 seconds have

elapsed. The time of the fastest player will blink and that player’s indicator light will turn on. If the times are equal, the times

will blink and both player indicator lights will turn on. If neither player has successfully completed the shots, then the display

will show “00”.

In the one player mode, after pressing “ON/OFF START” the LED will display a 5 second countdown. The indicator light will

show against PLAYER 1 and the target will move into position. After the sound ﬁnishes, the LED will countdown from 60

seconds. Each time the target is shot successfully, a sound is heard. PLAYER 1’s turn ends after the target has been shot 3

times, or the 60 seconds have elapsed. Then the LED displays a 5 second countdown, the target moves into position and the

game begins again. If the target is not shot within 2 minutes then the game turns off.

Press and hold “ON/OFF START” for 2 seconds to turn the game off.

If the game is inactive for a period of 5 minutes then it will turn off. There is no sleep mode.

Battery Box: Unscrew the bolt using a screwdriver and open the battery box. Insert 3x1.5v “AA” batteries ( not included) in

the sequence of polarity as shown on the inside cover. Then close the cover using a screwdriver.

BATTERY INSTALLATION

ELECTRONIC SCORER OPERATION

SG040Y20001 www.medalsports.com5(Continued on the next page)

English

The batteries must be installed according to their correct polarization (+ and -).

Please clean the battery contacts and also those of the device prior to battery installation.

If the game will not be used for a long period of time, we recommend removing the batteries.

REMINDING:

Requires 3x1.5V AA batteries (not included).

Do not mix old and new batteries.

Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc.) batteries.

WARNING

English

DISCLAIMER

SG040Y20001 7(The last page) www.medalsports.com

Changes or modiﬁcations not expressly approved by the party responsible for compliance could void the user’s

authority to operate the equipment.

WARNING

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15

of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more of the following measures:

This device complies with the Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference; and (2) This device must accept any interference received,

including interference that may cause undesired operation.

For additional resources, please contact Medal Sports Corp.

1300 Melissa Drive, Suite 124, Bentonville, AR 72712

Toll Free: 877-472-4296

NOTE

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

•

www.medalsports.com

MD Sports SG040Y20001 User manual

Brand: MD Sports

Model: SG040Y20001

Category: Skill games

Type: User manual

Download PDF

report

MD Sports SG040Y20001 User manual

MD Sports SG040Y20001 User manual

Related papers

Other documents