LG 10536AA.ENWAARZ Installation guide

Type
Installation guide
• Drilling Point
Pipe Hole in Piercing Surface Work Position (Left Pipe)
• Product Bottom line
• Horizontal Setting Line
P/No.: 3828A20923D
• Drilling Point
Pipe Hole in Piercing Surface
Work Position (Right Pipe)
• Product out line
• Drilling Point
• Drilling Point
• Plastic anchors
INSTALLATION GUIDE MAP
10mm
• Installation process
• Put an Installation Guide Map on the desired surface.
• Make a hole diameter of 6mm and depth of 30-35mm
when drilling a screw point.
• Drive the four plastic anchors into drilled points.
• Hang the hole of product at the upper screws.
(In this time, Remove the map)
(Falling attention)
• Check the fixed product
with light power.
• Look at suited horizon by horizontal meter on the
horizontal setting line, and Fix lighty the map by
adhesive tape.
• Refer to No.5 on page 7 when making a hole in the wall.
First, Drive the two points of the upper parts by screws.
(Leave 10mm for hanging product)
• Drive the lower parts after facing the hole of product
with Plastic anchors, and fix completely
the upper screws.
• In case of nothing wrong in the matter,
connect the pipe and the wire.
(Installation manual reference)
• Horizontal meter
INSTALLATION GUIDE MAP
• Rear side of product
• Horizontal Setting Line
INSTALLATION GUIDE MAP
500
513
525
INSTALLATION GUIDE MAP
INSTALLATION GUIDE MAP
INSTALLATION GUIDE MAP
INSTALLATION GUIDE MAP
• Plastic anchors
  • Page 1 1

LG 10536AA.ENWAARZ Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI