IMPORTANT: Read entire instruction sheet before install-
ing ledgestone refractory kit.
This ledgestone refractory kit is approved for use with
DVF-36(N, P)(H, L, S)(R, T)-D and DVF-42(N, P)(H, L, S)(R,
T)-D series replaces. Do not use ledgestone refractory
kit in any other replace models.
If any of these parts are missing or damaged, contact dealer where
you purchased this kit. If they cannot supply original replacement
parts, either contact your nearest Parts Central or call FMI PROD-
UCTS, LLC at 1-866-328-4537 for information.
Note: This installation requires the gas supply line to be disconnected
before removing log assembly. Call a qualied service person to
disconnect gas supply from replace.
IMPORTANT: Always handle Ledgestone refractory panels with
two hands.
WARNING: Turn off, unplug, and let replace cool
before installing ledgestone refractories. Only a quali-
ed service person should service and repair replace.
Ledgestone Refractory Panel Kit Installation Instructions
Models: BLY36STL and BLY42STL
Figure 1 - Ledgestone Refractory Kit
Rear
Refractory
Left
Refractory
Left Front
Refractory
Center Front
Refractory
Note: Brick pattern
may look different from
illustration
Right
Refractory
Right Front
Refractory
Retaining
Brackets
Parts included with these kits:
Tools required:
• Phillips Screwdriver
• 5/16" Hex Socket Wrench or Nut Driver
KEY
NO. PART NO. DESCRIPTION QTY.
1 125123-04 Rear Refractory, 42" Ledgestone • 1
125087-04 Rear Refractory, 36" Ledgestone • 1
2 125125-04 Left Refractory, 42" Ledgestone • 1
125089-04 Left Refractory, 36" Ledgestone • 1
3 125127-04 Right Refractory, 42" Ledgestone • 1
125091-04 Right Refractory, 36" Ledgestone • 1
4 125129-04 Left Front Refractory 42" Ledgestone • 1
125093-04 Left Front Refractory 36" Ledgestone • 1
5 125131-04 Center Front Refractory 42" Ledgestone • 1
125095-04 Center Front Refractory 36" Ledgestone • 1
6 125130-04 Right Front Refractory 42" Ledgestone • 1
125094-04 Right Front Refractory 36" Ledgestone • 1
7 120520-01 Retainer, Refractory • • 3
8 11166 Screw 10 x 1/2 HWH LGM ZINC (OXI) • • 6
BLY36STL
BLY42STL
NOTICE: Log set/burner must be removed before install-
ing ledgestone refractories. Refer to log base assembly
in owner's manual.
WARNING: A qualied service person must con-
nect and disconnect replace with gas supply. Follow
all local codes.