2. Home
  3. Do-It-Yourself tools
  4. Power tools
  5. Power planers
  6. Woodstock
  7. Planer

Woodstock Planer, rotacator, rotacator Planer User manual

  • Hello! I am an AI chatbot trained to assist you with the Woodstock Planer User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

1. Disconnectplanerfrompowersourcebeforeperforminganyoftheseadjustments.
2. Confirmthattheknivesareproperlysetwithinthecutterheadusingthefactoryknife
settingjig.
3. Adjustdepthofcutsothatthecutterheadisapproximately4"abovethetable.
4. InserttheflatpointscrewtipintotheRotacator
®
.

1. Rotatedialindicatorto“Up-reading”position(seeFigure1).
2. Placethedialindicatorbetweenthebedandcutterheadatoneendofthecutterhead
3. Graduallyreducethedepthofcutuntilthedialindicator’splungerisslightlydepressed
byoneoftheknives.Makesurethattheknifeisatthelowestpointofitscuttingarc.
4. Notethereadingonthedialindicatorface.
5. Removethedialindicatorandplaceitinthesamepositionattheoppositeendofthe
knife.Readthedialindicatoragain.Ifthereadingisnotequaltothefirstone,adjust
onesideoftheplanerbeduntilthereadingsarethesameatbothendsoftheknife
.

1. Rotatethedialindicatortothe“Down-reading”position(seeFigure2).
2. Placethedialindicatoronthesurfaceoftheplanerbed.
3. Loosenthesetscrewofthedialindicator,thenrotatethefacedialuntilthezerois
alignedwiththepointer.Tightenthesetscrew.
4. Placethedialindicatoronthesurfaceoftheplanerbedsotheplungeristouchingthe
highpointofoneendofthebedroller.
5. Adjusttheroller’sheightabovetheplanerbedtothespecificationsinyourplaner
instructionmanual.
6. Repeatsteps4and5attheoppositeendofthesameroller.
7. Repeatsteps4,5and6fortheotherbedroller.

1. Consultyourplanerinstructionmanualtodeterminetheproperrelationshipofthe
infeedandoutfeedrollersandchipbreakertotheknivesorcutterhead.Adjustas
neededpertheinstructionmanual.



Copyright©1994,WoodstockInternational,Inc.12/06 8878
Up-reading Position
Down-reading Position
Figure 1
Figure 2
/