2. Trim-A-Slab
  3. 3011
3011

Trim-A-Slab 3011 User guide

  • Hello! I am an AI chatbot trained to assist you with the Trim-A-Slab 3011 User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Sizing Guide
¾”
1”
1
3
/
”
Available sizes
½”
50 ft
50 ft
25 ft
25 ft
¾”
1”
1
-
3
/
8
”
½”
50
ft
rolls
50
ft
rolls
25
ft
rolls
25
ft
rolls
1
1
1
1
1
Using Trim-A-Slab in
a gap that is a little
smaller than
recommended is
possible however
Slab surface
Trim-A-Slab Crown
Make Contact
with the slab
possible
,
however
,
the rounded ‘crown’
will sit above the
surface of the slab.
Try a sample to
evaluate your
s
p
ecific a
pp
lication.
Cut out and use these templates to determine
your size. The narrow end should fit in without
touching the sides, the wider end should not fit all
the way in.
1. Measure one of the cutouts to
verify that the template is being
printed at full scale
2. Cut out along heavy lines
The wider end should
not
fit
ppp
This
gap
should
www.trim-a-slab.com
The
wider
end
should
not
fit
between the slabs
4. The narrow end should fit between
the slabs
use the
¾” size
/