-

Connect the WHEEL (1), LEFT FRAME (2), and RIGHT FRAME (3) using the ROTATION SHAFT (7).

Install the LEFT FRAME (2) and the RIGHT FRAME (3) to the sides of the CROSS FRAME (4) using FLAT

WASHERS Φ11*Φ20*2 (14), NUTS M10 (16), and HEX BOLTS M10*65 (18). (Don’t tighten the bolts.)

Insert a COTTER PIN (19) into each hole at the end of the ROTATION SHAFT (7).

WASHERS Φ11*Φ20*2 (14), NUTS M10 (16), and HEX BOLTS M10*65 (18). (Tighten the bolts.)

(5 & 6) and secure each one with a FLAT WASHER Φ13.5*Φ24*2.5 (15) and NUT M12 (17).

This concludes the WWBRW Owner’s Manual.

This equipment must be used with care by capable and competent individuals under supervision, if necessary.

The use of any fitness equipment, including this one, involves the potential risk of injury. You accept and assume full

responsibility for any and all injuries, damages (both economic and non-economic), and losses of any type, which may

occur, and you fully and forever release and discharge Titan, its insurers, employees, officers, directors, associates, and

agents from any and all claims, demands, damages, rights of action, or causes of action, present or future, whether the

same be known or unknown, anticipated, or unanticipated, resulting from or arising out of the use of said equipment.