Western UTS Extension Kit #95461 (7 GA.) & 95466 (STS) Installation guide

Hello! I have reviewed the installation instructions for the Western 95461 and 95466 Extension Kits. This document details how to assemble the extension kit, fasten it to the spreader, and secure it using either drilling and screws or welding. I am ready to assist you with any questions you may have about the installation process described in the instructions.
What type of bolts are used to assemble the extension kit?

What size holes need to be drilled to secure the extension?

What size screws are required to secure the extension after drilling?

UTS EXTENSION KIT INSTALLATION INSTRUCTIONS

95461 (7 GA.) AND 95466 (STS)

SAFETY PROCEDURES

INSTALLATION INSTRUCTIONS

1. Assemble Extension Kit as shown, using the

1/2-13 x 1-3/4" carriage bolts and 1/2-13 hex

locknuts included in the kit.

The company reserves the right under its product improvement policy to change construction or design details and furnish equipment when so

altered without reference to illustrations or specifications used.

CAUTION

Read instructions before performing

modifications. Use standard methods and

practices when working on spreader including

wearing proper personal protective safety

equipment.

Lit. No. 95526 Printed in USA May 15, 2003

Extension

Mount

Extension

Bar

Extension

Bolting Plates

2. Fasten the assembly to spreader using hardware

supplied with the UTS Mounting Kit.

3. The extension can be secured to the spreader by:

a. Transfer and drill four (4) 7/32" holes in

spreader. Secure with 1/2-13 x 1-1/2" hex cap

screws and 1/2-13 hex locknuts,

b. weld extension securely to spreader.

4. Install spreader to truck according to the spreader

installation instructions.

1/2-13 x 1-1/2" Hex Cap Screws

1/2-13 Hex Locknuts

Shown from bottom of spreader.