Astria Fireplaces ERT3000-old Instruction Sheet

Astria Fireplaces
Brand
Astria Fireplaces
Model
ERT3000-old
Type
Instruction Sheet

This manual is also suitable for

HEARTH PRODUCTS
KITS AND ACCESSORIES
900595-00
REV. B 06/2019
Cat. No. Model Description
H1538 TK3-36BL 3-pc. Black Trim Kit, 36
H1540 TK3-36BS 3-pc. Stainless Trim Kit, 36
H3435 TK3-33BL 3-pc. Black Trim Kit, 33
H1932 TK3-33BS 3-pc. Stainless Trim Kit, 33
INSTALLATION INSTRUCTIONS FOR TRIM KITS FOR USE WITH MODELS LISTED BELOW
[FIREPLACE MODELS: MPE-33-3, MPE-36-3, ERT3033, ERT3036, SPARK 33, SPARK 36, CAPELLA 33 AND CAPELLA 36]
KIT CONTENTS
1 ea. Top Panel
1 ea. Left Side Panel
1 ea. Right Side Panel
6 ea. Magnets
1 ea. Instructions Sheet
* NOTE: Trim Kits with Brass and Stainless Finishes also include:
1 ea. Left Side Channel
1 ea. Right Side Channel
1 ea. Top Channel
Double-sided tape on panels
(If the kit you purchased includes channels and double-sided tape,
they should be used)
TOOLS REQUIRED
None
INSTALLATION INSTRUCTIONS
This kit contains trim panels used to finish the gaps between the wall-board
or optional mantel and the fireplace, providing the appliance a finished
built-in look.
ENSURE FIREPLACE IS COOL TO THE TOUCH BEFORE STARTING INSTAL-
LATION OF THE TRIM KIT.
Step 1. Place 2 magnets on each side of the fireplace, placed at approxi-
mately 8” from the top and 8” from the base. See Figure 2.
Left Panel
Right Panel
Top Panel
*Side Channels
Magnets
*Top Channel
~
8”
Figure 1
CAUTION: CAREFULLY SEPARATE THE MAGNETS BY TWISTING THEM
APART. BE VERY CAREFUL WHEN HANDLING, BECAUSE THE MAG-
NETS ARE VERY POWERFUL AND CAN SNAP TOGETHER UNEXPECT-
EDLY AND POSSIBLY PINCH THE SKIN OR FRACTURE THE MAGNETS.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Figure 2
Figure 3
Step 2.
• Brass and Stainless Trim Kits - Proceed to Step 3.
• Black Trim Kits - Proceed to Step 4.
Step 3. Place the side channels over the magnets (see Figure 3). Ensure
that the two side channels are flush with the bottom of the fireplace.
The wider side of the side channel should be on the front of the
fireplace face after installation.
Step 4. Peel off the backing on the double-sided tape on the backside of
each side trim panel (see Figure 4). Avoid touching the sticky
surface of the tape. 1
06/18/2019
Ensure
Channel is
Flush with
Base
Side
Channel
Approximate
Magnet
Placement
Backing
Double
Sided
Tape
Backside of Side
Trim Panel
Right Side
Trim Panel
Magnet
Backside of Top
Trim Panel
* Black Trim kits do not include channels or double-sided
tape. See Note on Page 1.
Top Channel *
Double-sided Tape *
~3”
Typical
Figure 4
Figure 5
Step 5. Install the side trim panels onto each side of fireplace face as fol-
lows:
• Brass and Stainless Trim Kits – Place side trim over channels, then press
firmly so double sided tape adheres panels to channels (see Figure 5).
• Black Trim Kits – Place side trim panels over magnets on each ¬side
of the fireplace face as shown in Figure 5.
NOTE: Magnets were installed on Step 1, Figure 2.
Step 6.
• Brass and Stainless Trim Kits - Peel off the backing on double-sided tape
on the backside of the top trim panel. Press fit the top channel against the
top trim panel as shown in Figures 6 and 7.
• Black Trim Kits – Proceed to Step 7.
Step 7. Place 2 magnets on the backside of the top trim panel as shown in
Figure 6.
Figure 6
Step 8. Place the Top Trim Panel over the Side Trim Panels as shown in
Figure 7.
• Brass and Stainless Trim Kits – The metal channel should go behind the
side trim panels. Squeeze top and side trim pieces together.
• Black Trim Kits – The magnets act as support to hold the trim panel in
place.
Figure 7
Printed in U.S.A. © 2015 Innovative Hearth Products
P/N 900595-00 REV. B 06/2019
Innovative Hearth Products (IHP) reserves the right to make changes at any time, without notice,
in design, materials, specifications, prices and also to discontinue colors, styles and products.
Consult your local distributor for fireplace code information.
1769 East Lawrence Street • Russellville, AL 35654
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
2
  • Page 1 1
  • Page 2 2

Astria Fireplaces ERT3000-old Instruction Sheet

Astria Fireplaces
Brand
Astria Fireplaces
Model
ERT3000-old
Type
Instruction Sheet
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents