Lambro 544 Installation guide

  • I've reviewed the provided installation instructions for the vent. The document details the steps for a proper installation, emphasizing cutting a specific sized hole, sliding the vent into place, and securing it with screws. It also advises on caulking if needed. I'm ready to assist you with any questions you have about these instructions.
  • What size hole should I cut?
    How should I secure the vent?
    Do I need to caulk?
C
A
L
I
D
A
D
D
E
S
D
E
1
9
6
7
Q
U
A
L
I
T
Y
S
I
N
C
E
1
9
6
7
Q
U
A
L
I
T
E
D
E
P
U
I
S
1
9
6
7
Cut a 4 1/4” hole through the outside wall or use existing hole.
Corte un orificio de 10.8 cm pulgadas a través de la pared exterior o use un
orificio existente.
From the outside, slide pipe through the hole opening until the vent is
flush against outside wall surface.
Del exterior, la pipa de la diapositiva con la abertura del agujero hasta la
campana preferida es rasante contra superficie exterior de la pared.
Secure to outside wall using 4 screws (Not Included). Caulk around vent
and outside wall if necessary.
Se fija a la pared exterior usando 4 tornillos (no se incluyen). Si es
necesario, calafatee alrededor de la ventila, entre ésta y la pared exterior.
1
2
3
Installation Instructions:
Check and comply with local building codes.
Instrucciones de instalación:
Revise y cumpla los codigos locales de construccion.
/