Philips AVENT SCF285/01 User manual

Register your product and get support at

www.philips.com/welcome

SCF287, SCF286, SCF285, SCF284

Page is loading ...

6

Introduction

Congratulations on your purchase and welcome to Philips! To fully benefit from the support that

Philips offers, register your product at www.philips.com/welcome.

General description (Fig. 1)

A Lid with grip

B Small basket

C Large basket

D Heating element with water reservoir

E Base

F Mains cord

G Power-on button

H SCF287/SCF286:Sterilising light

I SCF287/SCF286: Ready light

J SCF285/SCF284:Sterilising light

K Dishwasher basket (SCF287/SCF286 only)

L Tongs

Note: You can nd the type number of your steriliser on the bottom of the appliance.

Important

Read this user manual carefully before you use the appliance and save it for future reference.

Danger

- Never immerse the base, the mains cord or the mains plug in water or any other liquid.

- Failure to follow the descaling instructions may cause irreparable damage.

- Never disassemble the base to avoid the risk of electric shock.

Warning

- This appliance is not intended for use by persons (including children) with reduced physical,

sensory or mental capabilities, or lack of experience and knowledge, unless they have been given

supervision or instruction concerning use of the appliance by a person responsible for their safety.

- Children should be supervised to ensure that they do not play with the appliance.

- Keep the appliance and its mains cord out of the reach of children.

- Check if the voltage indicated on the appliance corresponds to the local mains voltage before

you connect the appliance.

- Do not use the appliance if the plug, the mains cord or the appliance itself is damaged.

- If the mains cord is damaged, it must be replaced by Philips, a service centre authorised by

Philips or similarly qualified persons in order to avoid a hazard.

- There are no serviceable parts inside the electric steam steriliser. Do not attempt to open,

service or repair the electric steam steriliser yourself.

- The appliance becomes extremely hot during sterilisation and may cause burns if it is touched.

- Beware of hot steam that comes out of the vent in the lid or when you remove the lid. Steam

can cause burns.

- Do not touch the base, the baskets and the lid during or shortly after sterilisation because they

are very hot. Only lift the lid by its grip.

- Never move or open the appliance when it is in use or when the water in it is still hot.

- Never place items on top of the appliance when it is in use.

- Only use water without any additives.

- Do not put bleach or other chemicals in the appliance.

- Only sterilise baby bottles and other items that are suitable for sterilisers. Check the user

manual of the items you want to sterilise, to make sure they are suitable for sterilisers.

ENGLISH

- If you want to stop the sterilisation process, unplug the appliance (SCF285/SCF284) or press the

power-on button (SCF287/SCF286).

- This appliance is intended for household use only.

Caution

- Never use any accessories or parts from other manufacturers or that Philips does

not specifically recommend. If you use such accessories or parts, your guarantee becomes

invalid.

- Do not expose the appliance to extreme heat or direct sunlight.

- Always let the appliance cool down before moving or storing it.

- Do not sterilise very small items which can fall through the holes in the bottom of the basket.

- Never place items directly on the heating element when the appliance is switched on.

- Do not use the appliance if it has fallen or is damaged in any way. Take it to an authorised Philips

service centre for repair.

- Always place and use the appliance on a dry, stable, level and horizontal surface.

- Do not place the appliance on a hot surface.

- Do not let the mains cord hang over the edge of the table or worktop on which the

appliance stands.

- Always pour any remaining water out of the appliance after use and when the appliance has

cooled down.

- Always unplug the appliance after use.

- Environmental conditions, such as temperature and altitude, may affect the functioning of this

appliance.

Electromagnetic fields (EMF)

This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled

properly and according to the instructions in this user manual, the appliance is safe to use based on

scientific evidence available today.

Before first use

When you use the appliance for the first time, we advise you to let it complete one sterilisation

process with empty baskets.

Note: Heating up takes approx. 4 minutes and sterilising takes approx. 6 minutes.

1 Use for example a baby bottle and pour exactly 100ml tap water directly into the water

reservoir of the base (Fig. 2).

2 Place the large basket on the base (Fig. 3).

3 Place the small basket on the large basket (Fig. 4).

4 Place the lid on top of the small basket (Fig. 5).

5 Put the plug in the wall socket.

6 Press the power-on button to switch on the appliance. (Fig. 6)

Note: If you plug in the appliance after you have pressed the power-on button, the steriliser starts to heat

up immediately.

SCF287/SCF286

, The sterilising light lights up to indicate that the appliance starts operating.

, When the sterilisation process is finished, the ready light goes on. After 3 minutes the ready

light goes out to indicate that you can now safely open the steriliser.

SCF285/SCF284

, The sterilising light lights up to indicate that the appliance starts operating.

ENGLISH 7

, When the sterilisation process is finished, the appliance switches off automatically.

7 After the appliance has cooled down completely, remove the lid, the small basket and the

large basket and wipe them dry.

8 Let the appliance cool down completely for approx. 10 minutes before you use it again.

Note: The appliance does not work for 10 minutes after a sterilising cycle, it needs to cool down rst.

Preparing for use

Preparing for sterilising

Before you put the items to be sterilised in the steriliser, clean them thoroughly in the dishwasher or

clean them by hand with hot water and some washing-up liquid.

Using the dishwasher basket (SCF287/SCF286 only)

Use the dishwasher basket to preclean the items you want to sterilise.

1 Open the two sections of the lid of the dishwasher basket and place the bottles and

accessories in the basket (Fig. 7).

Note: Make sure that the bottles are placed upside down.

2 Close the two sections of the lid of the dishwasher basket (Fig. 8).

3 Place the basket in the dishwasher.

4 Switch on the dishwasher and let it complete the dishwashing cycle.

5 When the dishwasher is finished, take out the dishwasher basket and make sure that the

dishwasher basket and all items to be sterilised, are clean. If not, clean them by hand.

6 Place the dishwasher basket completely into the large basket of the steriliser.

Note: You can leave the dishwasher basket inside the large basket with the two sections of the lid

opened.

Assembling the steriliser

There are several ways to assemble the steriliser.

1 With only the small basket on the base to sterilise small items such as soothers (Fig. 9).

2 With only the large basket on the base to sterilise medium-sized items such as breast pumps,

toddler plates or toddler cutlery (Fig. 10).

3 With the large basket and the small basket on the base to sterilise up to 6 11oz/330ml bottles.

Place the bottles upside down in the large basket and place the bottle dome caps, screw rings

and teats in the small basket (Fig. 11).

Note: When you ll the small basket, put the teats on the bottom, place the screw rings loosely on top of

the teats and clip the bottle caps onto the two pillars in the small basket.

Note: Make sure all parts that need to be sterilised are completely disassembled and place them in the

basket with their openings pointing down to prevent them from lling up with water.

Using the appliance

Only place items in the steriliser which are suitable for sterilising. Do not sterilise items that are

filled with liquid, e.g. a teether with cooling fluid.

Note: Before you sterilise bottles and other items, clean them rst.

1 Use for example a baby bottle and pour exactly 100ml tap water directly into the water

reservoir of the base (Fig. 2).

ENGLISH8

2 Assemble the steriliser (see section ‘Assembling the steriliser’) and place the items to be

sterilised in it.

3 Place the lid on top of the small or large basket (Fig. 5).

4 Put the plug in the wall socket.

5 Press the power-on button to switch on the appliance (Fig. 6).

Note: If you plug in the appliance after you have pressed the power-on button, the steriliser starts to heat

up immediately.

SCF287/SCF286

, The sterilising light lights up to indicate that the appliance starts operating.

, When the sterilisation process is finished, the ready light goes on. After 3 minutes the ready

light goes out to indicate that you can now safely open the steriliser.

SCF285/SCF284

, The sterilising light lights up to indicate that the appliance starts operating.

, When the sterilisation process is finished, the appliance switches off automatically.

6 Remove the lid.

Wait until the appliance has cooled down before you remove the lid.

Be careful, hot steam may come out of the steriliser.

7 Remove the bottles and other items from the basket. Use the tongs to remove the

smaller items.

Be careful, the sterilised items may still be hot.

Note: Make sure you wash your hands thoroughly before you touch the sterilised items.

8 Unplug the appliance and wait until the appliance has cooled down completely.

9 Pour out any remaining water from the water reservoir and wipe the water reservoir dry.

Note: The appliance does not work for 10 minutes after a sterilising cycle; it needs to cool down rst.

Cleaning

Do not use abrasive or aggressive cleaning agents (e.g. bleach) or a scouring pad to clean this

appliance.

Never immerse the base, the mains cord or the mains plug in water or any other liquid.

Note: The steriliser is not dishwasher-proof. The baskets and the lid can be cleaned with hot water and

some washing-up liquid.

1 Always unplug the appliance and let it cool down before you clean it.

2 Clean the base with a moist cloth.

3 Clean the other parts in hot water with some washing-up liquid.

Note: After cleaning, store the steriliser in a clean, dry place.

Descaling

When you use the steriliser, small spots may appear on the heating element in the base. This is scale

that is building up. The harder the water, the faster scale builds up. Descale the steriliser at least

every 4 weeks to ensure that it continues to work effectively.

ENGLISH 9

1 Pour 80ml/2.7oz of white vinegar (5% acetic acid) and 20ml/0.7oz of water into the water

reservoir.

2 Leave the solution in the water reservoir until the scale has resolved.

3 Empty the water reservoir, thoroughly rinse it and wipe the base with a damp cloth.

Environment

- Do not throw away the appliance with the normal household waste at the end of its life, but

hand it in at an official collection point for recycling. By doing this, you help to preserve the

environment (Fig. 12).

Guarantee and service

If you need service or information or if you have a problem, please visit the Philips website at

www.philips.com or contact the Philips Consumer Care Centre in your country. You find its phone

number in the worldwide guarantee leaflet. If there is no Consumer Care Centre in your country,

go to your local Philips dealer.

Frequently asked questions

This chapter lists the questions most frequently asked about the appliance. If you cannot find the

answer to your question, contact the Consumer Care Centre in your country.

Question Answer

Why does water flow out of

the steriliser?

You may have poured too much water into the steriliser. Do

not pour more than 100ml water in the water reservoir.

Why are there white spots in

the water reservoir, the baskets

or the lid?

Scale build-up is normal and occurs more quickly in hard water

areas. Descale the appliance regularly (see chapter ‘Descaling’).

Why does a lot of steam

escape from under the lid?

Check if the lid has been placed on the basket properly.

Why does the sterilisation

process take so long?

You may have poured too much water into the steriliser (see

chapter ‘Using the appliance’). The number of items placed in

the baskets and the number of baskets used determine the

actual sterilisation time.

Why is the sterilisation process

so short?

You may have poured too little water into the steriliser (see

chapter ‘Using the appliance’).

Why does the appliance start

to heat up immediately when I

plug it in?

You have pressed the power-on button before you plugged in

the appliance. When you press the power-on button before

you put the plug in the wall socket, the steriliser starts

operating immediately when you plug it in.

SCF285/SCF284: Why can’t I

restart the appliance.

The appliance does not work for 10 minutes after a sterilising

cycle, it needs to cool down first. Wait for 10 minutes, before

you switch on the appliance again.

SCF287/SCF286: Why doesn’t

the ready light go out, when I

restart the appliance?

The appliance does not work for 10 minutes after a sterilising

cycle, it needs to cool down first. Wait for 10 minutes, before

you switch on the appliance again.

ENGLISH10

Page is loading ...

Philips AVENT SCF285/01 User manual

This manual is also suitable for

Philips AVENT SCF285/01 User manual

in other languages

Related papers

Other documents