Melissa 640-131 User manual

Category
Vacuum cleaners
Type
User manual

This manual is also suitable for

14
14
INTRODUCTION
To get the best out of your new appliance, please read this user
guide carefully before using it for the first time. We also re
-
commend that you keep the instructions for future reference, so
that you can remind yourself of the functions of your apparatus.
SAFETY MEASURES
The appliance, cord or plug must not be placed in water or
any other liquid.
Never touch the appliance, cord or plug with wet or damp
hands.
Never leave the appliance unattended when it is switched on.
Children should be supervised when using it.
Switch the vacuum cleaner off and unplug it when it is not in
use, and before you change the dust bag or clean the air filter.
Avoid pulling the cord when removing the plug from the
socket. Instead, hold the plug. Keep hold of the plug when
rewinding the cord, so that it does not strike the appliance.
Keep the cord and appliance away from heat sources, hot
objects and naked flames.
Never use the appliance if it, the cord or plug is damaged or
if the appliance is not functioning correctly. Never use the ap
-
pliance unless it has a dust bag, air filter and air filter fitted.
Only use accessories manufactured or recommended by the
manufacturer.
The appliance is for indoor domestic use only. Do not use it
on wet surfaces. Take particular care when vacuuming stairs,
due to the risk of falling.
Do not use the appliance to vacuum up matches, hot ashes,
cigarette butts, hard or sharp objects, wet or damp substan
-
ces, combustible materials (petrol, solvents, etc.) or vapour
from these.
Do not vacuum fine dust from construction materials such as
sheetrock, brick, etc.
Do not cover the appliance’s suction or exhaust port. Ensure
that you keep clothing, hair and body parts away from the
nozzle and moving parts of the appliance.
Never try to repair the appliance yourself. If the apparatus,
cable or plug needs to be repaired, it should be taken to an
authorised service centre. Please contact the store where you
bought the appliance for repairs under guarantee.
KEY TO MAIN COMPONENTS OF THE APPARATUS
1. Dust bag cover handle
2. Hose connector
3. Bag change indicator
4. Hose
5. Handle
6. Air valve
7. On/off button
8. Button for automatic cord rewind
9. Telescopic tube
10. Floor nozzle
11. Brush change button
12. Furniture nozzle
13. Combination nozzle
14. Parking holder
15. Exhaust grille
16. Cord and plug
17. Holder for combination nozzle
18. Carrying handle
19. Parking holder
PREPARING THE APPLIANCE
Attach the hose (4) to the appliance by inserting it into the
hose connector (2) until you hear a click. To remove the hose,
press the buttons at the side of the hose and pull it out of the
hose connector.
Connect the two parts of the telescopic tube (9), and fit the
required nozzle (see under Use) to the end of the tube.
USE
Pull the cord (16) out of the appliance. The cord must not be
pulled out any further than the red mark. Plug in and switch
the power on.
Press the on/off button (7) to start and stop the appliance.
While in use, the suction strength can be regulated by ope
-
ning and closing the air valve (6) on the handle (5) at the end
of the hose.
The nozzles are to be used as follows:
Floor nozzle (10) Floors (brushes out)
Carpets (brushes in)
Combination nozzle (13) Radiators, corners, skirtings, etc. (retracted)
Furniture, curtains, drapes, books, frames, etc.
(extended)
Furniture nozzle (12) Furniture, etc.
UK
15
15
The floor nozzle has two settings. When cleaning hard sur-
faces (stone flooring, tiles, etc.), the nozzle brushes should
be extended. When cleaning carpets and rugs, the brushes
should be retracted into the nozzle. Press the brush change
button (11) to switch between the two settings.
Tip:
If you wish to interrupt vacuuming with the floor nozzle in or
-
der to move furniture and such, you can place the floor nozzle
in the vertical parking holder (14) on the back of the appara-
tus..
The bag change indicator (3) will normally be green. If it
changes to red when the vacuum cleaner is in use, or if the
suction strength is significantly reduced, the dust bag must
be changed. If the indicator remains red after the bag has
been replaced, it may be due to one of the following reasons:
o The hose or nozzle is clogged.
o The air filter is dirty.
Investigate what is causing the indicator to remain red and
deal with the problem. The appliance must not be used if the
indicator is red. This may cause irreparable damage to the
motor.
CHANGING THE DUST BAG
If the suction strength of the ap
-
pliance is reduced, this may be
because the bag needs changing.
Lift the floor nozzle from the
floor.
Switch the appliance on, and
keep an eye on the bag change
indicator. If it is red, the bag
must be changed.
Turn off the appliance again.
Remove the hose.
Lift the dust bag cover by pres
-
sing the dust bag cover handle
in and pushing the cover up
until it locks into place.
Carefully pull the dust bag out
of the plastic rails on the base
of the apparatus (see illustra-
tion).
Throw the bag in the bin. Make
sure that there are no holes in
it. Do not fold it.
Place a new bag in the rails on
the base of the apparatus. Check that it is fitted firmly and
correctly. Never use the apparatus unless it has a dust bag
fitted.
Close the cover and make sure that it locks into position with
a click.
CLEANING/REPLACING THE MOTOR FILTER
The motor filter is the filter behind
the dust bag. The appliance
must not be used if the motor
filter is not in place.
Open the dust bag cover by
pressing in the handle.
Remove the dust bag or push it
aside.
Remove the filter sponge (as
shown), or clean it as described
under Cleaning.
Place the filter sponge in the
plastic railings on the base of
the apparatus.
Remember to replace the dust
bag again.
We recommend that you clean the filter at least twice a year or as
needed.
CHANGING THE AIR FILTER
The rear luft filter, which is located
behind the exhaust grille (15), filters
the exhaust air emitted by the ap-
pliance. The appliance must not be
used if the air filter is not in place.
Remove the exhaust grille by
pressing down the release
button and pulling the exhaust
grille out.
Remove the filter (as shown)
and replace it with a new one.
Close the exhaust grill so that it
locks into place iwth a click.
We recommend replacing the air
filter after 4 to 6 months’ use, when
it becomes dirty, or if the suction
force of the appliance is reduced.
TRANSPORT AND STORAGE
You can lift and carry the appliance using the carrying handle
(18). Never pull or lift the appliance by the cord.
Before putting the appliance away, rewind the cord. Switch
off at the socket, unplug, and press the automatic cord re
-
wind button (8) until the cord is fully rewound.
The combination nozzle can be stored in the holder (17) on
the back of the appliance.
The floor nozzle can be placed in the parking holder (1) on the
back of the appliance during storage.
CLEANING
Clean the appliance by wiping it with a damp cloth.
You must not use any form of solvent, or strong or abrasive
cleaning agent.
Make sure all filters are kept clean (see above). Replace the
filters once they become worn or can no longer be cleaned.
INFORMATION ON DISPOSAL AND RECYCLING OF THIS
PRODUCT
Please note that this Adexi product is marked with this symbol:
This means that this product must not be disposed of together
with ordinary household waste, as electrical and electronic waste
must be disposed of separately.
In accordance with the WEEE directive, every member state must
ensure correct collection, recovery, handling and recycling of
electrical and electronic waste. Private households in the EU can
take used equipment to special recycling stations free of charge.
In some member states you can, in certain cases, return the used
equipment to the retailer from whom you purchased it, if you
are purchasing new equipment. Contact your retailer, distributor
or the municipal authorities for further information on what you
should do with electrical and electronic waste.
16
16
GUARANTEE TERMS
The guarantee does not apply:
if the above instructions are not followed
if the appliance has been interfered with
if the appliance has been mishandled, subjected to rough
treatment, or has suffered any other form of damage
if faults have arisen as a result of faults in your electricity
supply.
Due to the constant development of our products in terms of
function and design, we reserve the right to make changes to the
product without prior warning.
IMPORTER
Adexi Group
www.adexi.eu
We cannot be held responsible for any printing errors.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24

Melissa 640-131 User manual

Category
Vacuum cleaners
Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI