PocketPower SI100 Safety instructions
11
2 Safety instructions
2.1 General safety
z Only connect the device using the connection cable to the 12 V cigarette lighter or
the 12 V on-board socket of the vehicle.
z Do not connect the 230 V output of the inverter to a different 230 V source.
z Always disconnect the power supply when working on the inverter.
z Note that even after the fuse triggers, parts of the inverter remain live.
z Do not pull the plug out of the cigarette lighter by the cable.
z If the cable is damaged, it must be replaced to prevent possible electrical hazards.
z Do not operate the device if it is visibly damaged.
z This device may only be repaired by specialist personnel. Inadequate repairs can
lead to considerable hazards.
Should your device need to be repaired, please contact WAECO customer services.
z Pull out the plug:
– Before cleaning and care
– After use
z Ensure that the ventilation slots are not covered.
z Keep the inverter out of the reach of children.
2.2 Operating the device safely
z When using the device in a vehicle, make sure that it does not impair operation of the
vehicle.
z Before starting the device ensure that the power supply line and the plug are dry.
z Never start the device when your hands are wet.
z Only operate the device when you or another person can attend to it.
z Do not operate the device on hot surfaces.
z Do not operate the device near flames or other heat sources (heating, direct sunlight,
gas ovens etc.).
z Do not immerse the device in water.
z Protect the device and the cable against heat and moisture.
z WAECO cannot be held liable for damage resulting from improper usage or incor-
rect operation.
3 Scope of delivery
Quan-
tity
Description
1 SI100 inverter with built-in connection cable for 12 Volt cigarette lighter or 12
Volt on-board socket
1 Operating manual
MSI-100.book Seite 11 Mittwoch, 6. September 2006 3:58 15