Sunco Lighting 99355 User manual

Brand: Sunco Lighting

Model: 99355

Type: User manual

Sunco Lighting 99355 lets you control color temperature (3000K-5000K) and brightness (25%-100%) of your smart light fixture remotely. Save your preferred settings with the "SAVE" button. Grouping multiple lights is also possible. Use the handheld remote controller together with the standard hard-wired wall switch (or breaker panel) to ensure complete control and energy saving.

REMOTE FOR SPECTRA PANEL • 99355

OPERATING INSTRUCTIONS

Specifications subject to change without notice. Photos and line

drawings may not be to scale and are for general reference only.

ON Turn ON Turn OFF

Hand held remote controller cannot be used directly as the only on-o switch it

should be used together with the switch. The fixture needs to be turned o for the

night with a standard hard-wired wall switch (or at the breaker panel).

Turn o the light to save the current color temperature then turn on the light, the

last saved color temperature will be displayed by default.

MATCHING CODE FOR LIGHT

Holding the ‘ID’ button will keep the controller’s indicator on, then turn on the

light and release the ‘ID’ button after the light flashes, matching code complete.

Matching code for several lights simultaneously is available.

RELEASE THE CODE AND DISCONNECT LIGHT FROM REMOTE CONTROLLER

Press the bottom +together, then turn on the light, the light will flash to

finish releasing the code on

the lights.

GROUP SELECTING BUTTON

Grouping lights (matching code process needs to be completed first). Turn o the

lights, continue pressing

the group selection button for 3s, then turn on the lights the lights will flash to

finish grouping.

Save

SAVE BUTTON

Press and hold (3-5 seconds) the “SAVE” button until the light goes out, the

current brightness and color temperature are automatically saved. Turn o lights

then turn on, the last saved brightness and color temperature will be displayed by

default.

ALL GROUPS ARE SELECTED

COLOR TEMPERATURE AND BRIGHTNESS SELECTION

5000K 4000K 3500K 3000K

Color Temperature

25% 50% 75% 100%

Brightness

Increase

Brightness

Decrease

Brightness

Decrease

Color Temperature

Increase

Color Temperature

Power the light o then power it on, the last saved brightness (which is saved by the button “SAVE”) and

the last saved color temperature (which is saved by the button “SAVE” or “OFF”) will be displayed by

default. The defaulted factory setting of the light is 100% brightness and 4000K.

Batteries not included.

Requires 2 - AAA.

Sunco Lighting 99355 User manual

Sunco Lighting 99355 User manual

Sunco Lighting 99355 User manual

Related papers

Other documents