Tesla 914 Operating instructions

Hello! I've reviewed the provided instructions for removing the Motor Controller of the Cyberquad for Kids. This manual details the steps for safe removal, including disconnecting the battery, removing various screws, and handling the electrical connections. I'm ready to help answer your questions about the process described in the document.
What is the first step in removing the motor controller?

What tool is required to remove the screws in the battery housing?

How do I remove the seat?

How many screws are used to secure the power connector plate?

Cyberquad for Kids

Motor Controller Removal Instructions

Step 1: Remove the battery pack by engaging the battery latch and pulling the battery out of the compartment.

Step 2: Using a Phillips screwdriver, remove two screws within the battery housing.

Step 3: Remove the seat by lifting up on the rear edge and pulling back simultaneously.

Cyberquad for Kids

Motor Controller Removal Instructions

Step 4: Using a Phillips screwdriver, remove two screws securing the power connector plate.

Step 5: Using a Phillips screwdriver, remove four screws fastening the motor controller to the body.

Step 6: Disconnect all nine connectors attached to the motor controller, by squeezing the tabs and pulling both ends.

Cyberquad for Kids

Motor Controller Removal Instructions

Step 7: Cut the two zip ties that secure the wire harness to the body.

Step 8: With all nine connectors detached, remove the motor controller from the body.

Step 9: Remove the return envelope from the larger envelope. Place the motor controller in the return envelope with

the shipping label applied. Drop off at a UPS store to start the return process.