Brooklyn AURA
LED Task Light User Guide
ASSEMBLY INSTRUCTIONS
lamp to reveal the stabalizing pad.
• Clean the intended installation surface to remove dust or
particulates. If bottom of lamp loses its stickiness, it can be
cleaned with a wet cloth.
• A tripod screw mount is also included, for a more
permanent installation.
• Install the included power cord to rear of lamp and then
plug into any wall outlet.
USING YOUR LUX BROOKLYN AURA LED LAMP:
•Turn the light on by touching the power button on the front
of the lamp.
• Press the power button again to cycle through the three
brightness levels (600, 250, 20 lumens).
• The wireless Qi Charging pad will only work with
Qi-enabled devices. For a full list of compatible devices,
visit: https://www.wirelesspowerconsortium.com.
• NOTE: The wireless charger will generally charge any
compatible mobile device provided the case is no thicker
than 3mm. However, if the back panel is thicker, or if the
case contains a battery, cards, or other metal, it may
prevent the device from wirelessly charging.
• When using the lamp to charge your devices, unplug or
remove the devices once batteries are full.
SAFETY INFORMATION:
replaced; if the cable is damaged the entire power supply
must be replaced.
• For indoor use only; do not use outdoors or in damp
locations.
• Switch the lamp off before disconnecting the power.
• Do not look directly at the LEDs when they are illuminated.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation of the device.
Any changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s
authority to operate the equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the quipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Visit us at:
www.luxledlights.com
REVISION 100
CUSTOMER SERVICE:
For questions and assistance please contact us at:
805-329-5646 • [email protected]
/
