2. SCSI
  3. 4G IP Direct Wireless Communications Module
4G IP Direct Wireless Communications Module

SCSI 4G IP Direct Wireless Communications Module User guide

  • Hello! I'm a chat assistant that has reviewed the DirectWireless setup guide. This document contains instructions for setting up your new DTU 4G/IP communication device, including steps for contacting your control room, noting the serial number, and connecting the device to a control room. I am ready to answer your questions about the DirectWireless DTU 4G/IP device.
  • What is the first step I should take when setting up my DirectWireless device?
    What do I need to provide the Technical Support when I call?
    What is DTU?
SET UP
GUIDE
1300 555 570
[email protected]
www.scsi.com.au
Your Trusted Supplier in Security Communications
THANK YOU
for choosing DirectWireless™ as your communications device.
Below are the step-by-step instructions you should follow when setting up this device for the first time.
The SCSI Technical Support sta will connect your new DTU to the control room
and it will be ready for testing alarm events through.
1. Contact your control room and request a new monitored account number
for a DirectWireless connection. You will need this account number in Step 5.
2. Take note of the serial number of the DirectWireless unit (see picture at right).
3. Install the DirectWireless DTU as per the included instructions.
4. Once installed and powered up, call 1300 555 570 and select Tech Support.
5. Advise the Technical Support member that you have a DTU (Digital Transmission
Unit) to connect to “your control room” providing the serial number of the DTU
and the account number provided by the control room in step 1.
The serial number is
below the barcode.
/