2. SMANIA
  3. PET
PET

SMANIA PET Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the SMANIA PET Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
INSTRUCTIONS
PET DRINKING FOUNTAIN
FLOWY
PACKAGE CONTENTS
• Fountain
• Pump
• Power adapter
• Outflow pipe
• 4 × water filter
• Sensor (optional)
TECHNICAL SPECIFICATIONS
• Volume: 1,8 L
• Material: PC
• Dimensions: 172 × 172 × 165 mm
• Weight: 0,6 kg
INSTALLATION
Before installation
• Take out all the packaging and items from
the inside of the fountain.
Installing the filter
• Open the fountain and remove the filter
compartment on the fountain’s cover.
• Insert one of the included filters into the
filter compartment.
• Close the compartment.
Installing the water pump
• Place the water pump inside the fountain
near the specified cable slot. Press it down
to make it stick to the casing.
• Thread the cable through the slot.
• Use the slider on the water pump to
determine the water flow (it’s marked with
+ and -).
Assembling the fountain
• When you have completed the above steps,
place the cover on the tank. Ensure that the
water pipe slots onto the pump’s outlet and
that the cable slots align.
• Insert the included pipe into the outlet on
top of the cover if you wish to have the
water flow from a higher place.
Operation
• Connect the pump’s power cable to the
power adapter and plug it into an electrical
socket. The fountain should now start
pumping water.
• If your version of the fountain comes with
the motion sensor, refer to the next
section.
Motion sensor operation
• If you have the version of the fountain with
the motion sensor, plug the pump’s power
cable into the sensor.
• Attach the sensor close to the water
fountain with the suction cup (there is a
slot for the suction cup on the back of the
sensor) or the included double-sided
adhesive dot.
• The sensor turns ON the water pump when
it senses motion in a range of 0,1–3 m. It
turns OFF again after 30 seconds.
MAINTENANCE
• Clean the water container every two weeks,
increasing the frequency depending on the
water quality and the animal’s habits.
When cleaning the container, also replace
the water filter.
• Always unplug the water pump during
maintenance.
• Use regular running water to clean the
water tank. Do not use soap or detergents
of any kind in order to protect your pet’s
health.
• Do not use abrasive materials when
cleaning.
WARNINGS
• Always unplug the water pump during
maintenance.
• Do not pull on the cord when unplugging
the fountain.
• Do not overfill. Use the markings on the
side of the water tank to determine the
optimal water level.
• Never run the water pump outside of the
water. Always fill the tank before turning on
the pump.
• Protect your pet from chewing the cords.
• The power adapter shouldn’t come into
contact with water.
WARRANTY
The warranty is valid for 24 months. You can claim it
from DFVU d.o.o., Liparjeva 6a, 1234 Mengeš,
Slovenia, for a replacement product or a refund.
Send us your order number and purchase date in the
email, which is available by clicking on our logo in the
bottom right corner. The product has a lifetime of 24
months from the date of collection.
WEEE disposal and recycling symbol.
The WEEE symbol is attached to the
product in compliance with the EU
directive 2012/19/EU on Waste
Electrical and Electronic Equipment
(WEEE). It is intended to deter the
improper disposal of this product and
to promote reuse and recycling.
/