INSTRUCTION MANUAL
Repeat Stop
WHAT’S IN THE KIT
1 x Rail Square Fence◄
(600mm)
1 x Joining Bar◄
1 x Calibration Stop◄
1 x Connector Block◄
2 x Thumb Screw M6◄
2 x Nylon Washers◄
1 x Aluminium Stop ◄
1 x Add on Extrusion◄
(445mm)
2 x Allen Keys ◄
FIND ALL INSTRUCTION MANUALS AT
WWW.BENCHDOGS.CO.UK
RAIL SQUARE
FENCE
ADD ON
EXTRUSION
JOINING
BAR
NYLON
WASHERS ALLEN KEYS
CONNECTOR
BLOCK
CALIBRATION
STOP
THUMBSCREWS
ALUMINIUM
STOP
CONTACT@BENCHDOGS.CO.UK WWW.BENCHDOGS.CO.UK Q E M
FOR MORE INFORMATION PLEASE VISIT
Join your rail square fence and add on
extrusion using the joining bar. Tighten
the grub screws using the supplied allen
keys.
Once tightened, add your connector
block to support the join.
Attach your fence to your rail square
using the thumbscrews.
STEP 1 STEP 2 STEP 3
Repeat Stop
Attach your rail square to your rail and
secure using the cam screws. Align your
fence to the edge of the rail and tighten
the thumbscrews.
Add your calibration block to secure
the setup and tighten the grub screw
using the supplied allen keys.
Place the aluminium stop to the desire
measurement, place against the edge of
your material and proceed to cut.
STEP 4 STEP 5 STEP 6
Repeat Stop
CONTACT@BENCHDOGS.CO.UK WWW.BENCHDOGS.CO.UK Q E M
FOR MORE INFORMATION PLEASE VISIT
-
1
-
2
-
3
-
4
-
5
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Axminster TS-200-2 Operating instructions
-
Kreg Tool PRS1020 User manual
-
Record Power TS315 Original Instruction Manual
-
-
-
-
Rikon Power Tools 25-010 User manual
-
-
Festool DF 500 User manual
-
