1. Carefully remove all parts from the box. Place on a clean, soft surface.
2. Remove mounting plate (B) from canopy (F) by removing collar
ring (I).
3. Install mounting plate (B) to the junction box and secure with
mounting screws (C).
4. Holding fixture upright, slide collar ring (I) and canopy (F) pass though
rod (H) and rest on fixture body.
5. Hang fixture swivel ball (G) to the center of mounting plate (B) and
secure with set screw (D) using provided wrench (E). See diagram 1.
6. Wrap fixture ground wire (bare copper) around the green grounding
screw (see diagram 2). Tighten. Continue fixture ground wire and
connect to supply ground wire (usually green or bare copper) using
wire nut (A).
NOTE: It is imperative that the fixture is grounded.
7. Connect fixture neutral wire (white) to the supply neutral wire (usually
white) using wire nut (A).
8. Connect fixture hot wire (black) to the supply hot wire (usually black)
using wire nut (A).
CAUTION: Do not reverse the hot and neutral connections.
9. Make sure all wire connections are tight, then carefully tuck into the
junction box.
Lorino Large Semi-Flush Mount
Item # JN 4240
ASSEMBLY INSTRUCTIONS
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction
and operation of it, as well as the hazards involved. Inspect item and
contents carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver Slotted Screwdriver
NOTICE:
US
M
L
I
D
S
E
T
A
CB
G
Bulbs not included
E
D
F
K(4pcs)
M(1pc)
L(4pcs)
I
J
N(8pcs)
O
Diagram 3
Diagram 2
Diagram 4
J
OP
Diagram 1
E
D
H
