Assembling a Grow Tent (Generic Instructions)
Assemble the tent in an open, uncluttered area large enough to completely open, and lay
out, the tent cover.
Simplified Assembly Instructions
• Carefully open the packaging.
• Count all poles and match to parts list.
• Count all connectors and match to the parts list
• Set aside the Floor Pan. It will not be used until later.
• Unzip all zippers on the tent cover completely.
o Lay the tent cover out flat. (The floor will be at the bottom of a “t” shape.)
• Assemble the frame of the tent in the floor of the unit using included assembly
instructions.
• Pull the roof of the tent cover (at the top of the “t”) over the assembled frame.
o Straighten the corners of the tent cover, pulling the flap down and around the
roof of the frame.
o Zip the right and left doors half closed, creating the side walls.
o Pull left and right door flaps back to rear, top, outside corners and secure with
the provided Hook and Loop (Velcro) straps.
• Place the floor pan inside the tent floor and secure at the corners with the provided zip
ties, twine, or string.
Your tent has approximately a 150 lbs. load capacity.
• If your tent includes drop down accessory poles:
o Hang your grow light hoods, filters, etc. from these poles.
• If your tent does not include drop down accessory poles, only straight stability poles:
o Do not hang your grow lights, filters, etc. from these stability poles. Only
hang from the load bearing frame poles.
Ports
• The smaller accessory ports are generally used for electrical and water connections.
• The larger ports are generally used for air flow ducting.
o Close off ports when not in use for maximum airflow and light integrity.
/
