Unbranded VS7600-76 User guide

Assembling a Grow Tent (Generic Instructions)

Assemble the tent in an open, uncluttered area large enough to completely open, and lay

out, the tent cover.

Simplified Assembly Instructions

• Carefully open the packaging.

• Count all poles and match to parts list.

• Count all connectors and match to the parts list

• Set aside the Floor Pan. It will not be used until later.

• Unzip all zippers on the tent cover completely.

o Lay the tent cover out flat. (The floor will be at the bottom of a “t” shape.)

• Assemble the frame of the tent in the floor of the unit using included assembly

instructions.

• Pull the roof of the tent cover (at the top of the “t”) over the assembled frame.

o Straighten the corners of the tent cover, pulling the flap down and around the

roof of the frame.

o Zip the right and left doors half closed, creating the side walls.

o Pull left and right door flaps back to rear, top, outside corners and secure with

the provided Hook and Loop (Velcro) straps.

• Place the floor pan inside the tent floor and secure at the corners with the provided zip

ties, twine, or string.

Your tent has approximately a 150 lbs. load capacity.

• If your tent includes drop down accessory poles:

o Hang your grow light hoods, filters, etc. from these poles.

• If your tent does not include drop down accessory poles, only straight stability poles:

o Do not hang your grow lights, filters, etc. from these stability poles. Only

hang from the load bearing frame poles.

Ports

• The smaller accessory ports are generally used for electrical and water connections.

• The larger ports are generally used for air flow ducting.

o Close off ports when not in use for maximum airflow and light integrity.

This manual is also suitable for

Download PDF