Park Smart 10001 Operating instructions

6345 Nancy Ridge Drive, San Diego, CA 92121

(858) 625-0005 ● (800) 992-2018 ● Fax (858) 625-0010 ● Email: info@auto-care.com

Park Smart

™

Parking Mat

Installation Instructions

1. Position vehicle in desired location.

2. Lay Parking Mat next to driver's side front tire, positioned so the

handle is toward the front bumper and so the tire is in the middle of

the two bumps, on the Parking Mat.

3. Move vehicle back at least four feet.

4. Sweep floor where Parking Mat is to be installed.

5. Clean floor with rubbing alcohol, where the Parking Mat is to be

located, so double-sided tape will adhere to garage floor.

6. Slowly lift up one side of the Parking Mat, being careful not to allow

the Parking Mat to move from position.

7. Remove paper backing from double-sided tape.

8. Move Parking Mat over, to where the tire had been located,

approximately 10" to 12".

9. Press the double-side tape to floor, by standing on the flat tongue and

the flat area between bumps, on the Parking Mat. Park vehicle on

the Parking Mat for at least 5 minutes, helping to secure double-sided

tape to floor.

Made in U.S.A.

This manual is also suitable for

Download PDF