Magtek iDynamo User manual

Brand: Magtek

Model: iDynamo

Type: User manual

This manual is also suitable for

iDynamo 5

Magtek iDynamo 5 is a secure card reader authenticator that works with all supported iOS devices. It offers MagneSafe security, open standards encryption, immediate tokenization of card data, and MagnePrint® card authentication to protect data and prevent counterfeit cards. Merchants can leverage the power of their iOS devices without handling or storing sensitive card data.

iDynamo 5

iDynamo - iOS

Secure Card Reader Authenticator

Quick Installation Guide

www.magtek.com

From the company that leads with “Security from the Inside” MagTek has done it

again with the iDynamo, a secure card reader authenticator (SCRA) designed to

work with all supported iOS devices. The iDynamo offers MagneSafe security and

delivers open standards encryption with simple, yet proven DUKPT key management,

immediate tokenization of card data and MagnePrint

card authentication to maximize

data protection and prevent the use of counterfeit cards. Mobile merchants can now

leverage the power of their iPad, iPhone and iPod touch products without the worries

of handling or storing sensitive card data at any time.

Product Description

Diagram

Optional adapters

iPad Air 2

Magstripe swipe paths

Adapters make attaching to your different iOS devices simple and provide more

stability. The iDynamo 5 comes with several stability adapters.

Enclosed Stability Adapters

Part Number Description

21041140 For iPhone 8+, iPhone 7+, iPhone 6+

21041139 For iPhone 8, iPhone 7, iPhone 6

21041088 For iPhone 5/5s

1000001920 For iPad Air 2

21041137 For iPad Air, iPad mini 3, iPad mini with Retina display

21041086 For iPad with Retina Display

Part Number Description

21073144 Adapter Kit for iPad Air 2; iPhone 8+/7+/6+; iPhone 7/6/8; iPhone 5c; iPhone 5/5s; iPad mini 3,

iPad mini with Retina display; iPad mini; iPad Air, iPad with Retina Display; iPod touch 5th gen

21073107 Adapter Kit for iPhone 4, iPad, iPad 2 / 3 & iPod touch 3 & 4, iPhone 3GS

21041054 Adapter Kit for iPad 2/3

Lightning connector

iPad Air

iPad mini 3,

iPad Mini

with Retina

Display

iPad with

Retina Display

Optional adapter kits are available.

iPhone 5s

iPhone 5

iPhone 6

iPhone 7

iPhone 8

iPhone 6+

iPhone 6s+

iPhone 7+

The iDynamo is powered through the iOS device.

It only uses power during a transaction.

To charge your iOS device while the iDynamo is attached, connect the optional Micro-

USB cable (Micro-B) (MagTek Part #30019324) to the back of the iDynamo, and then

connect the opposite end (USB-A) to the appropriate Apple charging adapter.

Apple 12W USB Power Adapter for iPad and iPad with Retina Display.

Apple 5W USB Power Adaptor for iPhone, iPad mini, or iPod.

Power

www.magtek.com

An optional stylus is available at: http://tenonedesign.com/stylus.php

Some applications include a visual indication of whether the device is active or not.

Contact your representative to learn where you can download your application.

Signatures can be captured in certain applications by using a nger.

Commands

Optional Accessories

micro-USB connection USB connection

Charging cable (optional)

ONLY the MagTek USB cable can be used, PN 30019324

Compliance

FCC WARNING STATEMENT: This equipment has been tested and was found to comply with the limits for a Class B digital device pursuant to Part 15 of FCC Rules. These limits are designed to

provide reasonable protection against harmful interference when the equipment is operated in a residential environment. This equipment generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instruction manual, may cause harmful interference with radio communications. However, there is no guarantee that interference will not occur

in a particular installation.

FCC COMPLIANCE STATEMENT: This device complies with Part 15 of the FCC Rules. Operation of this device is subject to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

CANADIAN DOC STATEMENT: This digital apparatus does not exceed the Class B limits for radio noise from digital apparatus set out in the Radio Interference Regulations of the Canadian

Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la classe B prescrites dans le Réglement sur le brouillage

radioélectrique édicté par le ministère des Communications du Canada.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numériqué de la classe B est conformé à la norme NMB-003 du Canada.

CE STANDARDS: Testing for compliance with CE requirements was performed by an independent laboratory.

The unit under test was found compliant with standards established for Class B devices.

UL/CSA: This product is recognized per Underwriter Laboratories and Canadian Underwriter Laboratories 1950.

RoHS STATEMENT: When ordered as RoHS compliant, this product meets the Electrical and Electronic Equipment (EEE) Reduction of Hazardous Substances (RoHS) European Directive 2002/95/

EC. The marking is clearly recognizable, either as written words like “Pb-free”, “lead-free”, or as another clear symbol ( ).

MagTek ® Inc., 1710 Apollo Court, Seal Beach CA 90740 p 562-546-6400 | f 562-546-6301 | www.magtek.com

Made for

Legal

“Made for iPod” and “Made for iPhone” and “Made for iPad” mean that an electronic accessory has been designed to connect

specically to iPod or iPhone or iPad respectively, and has been certied by the developer to meet Apple performance standards.

Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.

iPod touch, iPhone and iPad are trademarks of Apple Inc., registered in the U.S. and other countries.

iPod, iPhone and iPad not included.

Technical Support

When calling the support team please have your reader charged and have the part

number and serial number(s) available.