5019 401 05074
Add the detergent as described in the
“Detergent and Additives” chapter of the
instructions for use.
1. Turn the
programme selector knob
clockwise to the desired programme.
2. Turn the
temperature selector
in any
direction to the desired temperature.
3.
Special options
can be selected.
4. Check that the door is firmly closed and
turn on the washing machine by pressing
the
“ON/OFF”
button. The indicator lights
up, indicating that the washing machine is
on.
Eco
(Øko)
The duration of the wash is extended and
the temperature reduced. In this way you
save energy while still obtaining good
washing results.
Intensive Rinse
(Kraftig skyl)
Increases the rinsing time and water
quantity. This additional option is
particularly suitable for areas with very soft
water, washing baby linen and helps people
with detergent allergies.
Rinse hold
(Skyllestop)
This option is particularly recommended for
the programme “Synthetics” or “Delicates”.
The laundry remains in the last rinse water
without being spun: discoloration of the
laundry or additional creasing is prevented.
Terminate the “Rinse Hold” option:
Press the “Rinse Hold” button again; the
wash cycle will terminate automatically with
the appropriate spin cycle for the current
programme.
CONSUMPTION DATA *
Programme Temperature
selector knob
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Programme
duration **
approx.
(hours : minutes)
Coloured Cotton
95 5.5 54*** 1.90 2:00
Coloured Cotton
60 5.5 49 1.04 2:20
Coloured Cotton
40 5.0 49 0.55 2:05
Synthetic
60 2.5 55 0.80 1:25
Synthetic
40 2.5 55 0.60 1:20
Delicate
40 1.5 60 0.60 0:40
Wool
40 1.0 50 0.35 0:35
Handwash
30 1.0 45 0.35 0:35
*
Consumption values
were measured in normalized conditions in compliance with Standard IEC 60456.
** The
programme duration
can also vary from the chart values. The washing machine is able to allow for
particular household conditions and to adapt the programme run time accordingly.
***To reduce the
water temperature
, some cold water is added at the end of the main wash cycle, before
the pump drains the water out.
POUR IN DETERGENT, CLOSE DOOR AND
SELECT PROGRAMME
SELECT SPECIAL OPTIONS
If you do not wish to spin the clothes, press
the Rinse stop button, turn the programme
selector knob to the “Drain” programme
and switch the machine on again.
Easy Ironing
(Stryg let)
Can be used together with Cotton and
Synthetics programmes to reduce creasing.
Increases the water quantity and the clothes
are spun very gently.
Spin Speed reduction
Reduces the preselected maximum spin
speed. In some programmes, the final
maximum spin speed is limited in order to
protect the laundry. Selecting a higher speed
is not possible.
The “Start Delay” allows to run the machine
at the consumer’s convenience, for example
at night when electricity is cheaper.
1. Select the desired programme, the
temperature and, if required, the
additional options.
2. Press the
“ON/OFF”
button.
The operating light and the “Start Delay”
“0” light flash.
3. Press “Start Delay” button within
6 seconds and select the desired
programme start time 3, 6 or 9 hours
ahead.
4. The programme starts at the preselected
time or, if no “Start Delay” has been
selected, after 6 seconds.
•
Correcting the “Start Delay”:
Switch
the washing machine off and on again
and select the new time within 6 seconds.
•
Cancelling the “Start Delay”:
Switch the washing machine off and on
again. The selected programme then
starts after 6 seconds.
• If the programme or the special options
are reselected after the “Start Delay” has
been started, then the new programme is
started after the time has expired.
Note:
When using liquid detergent
please use the measuring aid and pour
the detergent directly into the drum.
1. Switch off the washing machine by
pressing the “
ON/OFF
” button.
2. Set the programme selector to
programme setting “Drain”.
3. Start the programme by pressing the
“
ON/OFF
” button.
• At the end of the programme the
programme selector is located at the “O”
end position.
• Switch off the appliance, open the door
and take out the laundry.
• Turn off the tap and leave the door ajar
to allow the drum to dry out.
START DELAY
CANCEL PROGRAMME
PROGRAMME END
4gb05074.fm Page 2 Sunday, May 25, 2003 12:29 PM
Black process 45.0° 100.0 LPI