Whirlpool ART 769/NFV Program Chart

Brand: Whirlpool

Model: ART 769/NFV

Type: Program Chart

This manual is also suitable for

ART 766/NFV

What to do if... Possible causes: Solutions:

The control panel is off and the appliance does not

operate

There might be a problem with the electric power supply to the appliance.

Check that:

• there isn't a power supply failure

• the power plug is correctly inserted in the power socket and the two-pole switch, if present, is in the

correct position (on)

• the electric circuit safety devices installed in the house are fully functional

• the power supply cable is not broken

the green LEDs on the control panel are off and an

acoustic signal is heard.

Freezer door open alarm

This alarm activates when the freezer door is open for an extended time.

To deactivate the acoustic signal press the "Switch off acoustic alarms" button for 3 seconds or close the

freezer door.

The inside light does not work. The lamp might need replacing.

Disconnect the appliance from the electric power supply, check the lamp and replace with a new one if

necessary (see "Maintenance and Cleaning").

The temperature inside the compartments is not cold

enough.

There may be several causes (see "Solutions")

Check that:

• The doors are closed correctly

• The appliance is not placed near a heat source.

• the temperature set is appropriate.

• Air circulation through the ventilation grills at the bottom of the appliance is not obstructed (see

"Maintenance and Cleaning")

There is water at the bottom of the refrigerator compartment The defrost water drain is obstructed. Clean the defrost water drain hole (see "Maintenance and Cleaning").

The front edge of the appliance is hot at the door seal

edge.

This is not a fault. It is part of the design to prevent the formation of condensation. No solution is necessary.

The control panel does not operate: each time a button

is pressed an acoustic signal is heard and the green

lights flash 4 times.

The "Keypad lock" function is active. Deactivate the "Keypad lock" function as shown in the Quick Guide.

One or more green LEDs flash continuously and an

acoustic signal is heard (unless previously deactivated)

Fault Alarm

The alarm indicates that there is a fault with a technical component.

Call the authorised After-sales Service. To deactivate the acoustic signal press the "Switch off acoustic

alarms" button.

QUICK GUIDE

ROBGRUSHSKCZPLGB

Refrigerator compartment

A. Fan (depending on model)

B. Internal lamp (depending on model)

C. Shelves

D. LED lights (depending on model)

E. Crisper Shelf

F. Rating plate (at the side of crisper)

G. Crisper drawers

H. Control panel

N. Dairy products compartment

O. Door trays

P. Bottle holder (if provided)

Q. Bottle door trays

Least cold zone

Intermediate temperature zone

Coldest zone

Fruit & vegetables zone

Freezer Compartment

I. Upper drawer (freezing area)

L. Central and bottom drawers (for the conservation of

frozen and deep frozen foods)

M. Ice cubes container (if provided).

Note: All the shelves, doors trays and racks are

removable.

The ideal temperatures for preserving food have already

been set at the factory.

Before using the appliance carefully read the

instructions supplied.

Features, technical data and pictures may vary

depending on model.

On / Stand-By

Press and hold for 3 seconds to activate/deactivate

the appliance.

Note: This operation does not disconnect the

appliance from the power supply.

Temperature of the refrigerator compartment

The three green LEDs indicate the temperature level inside the

refrigerator compartment.

A different temperature can be set pressing the "Temp. °C" button.

The following temperature adjustments are possible:

LEDs on Set temperature

less cold

colder

Keypad lock

Keypad lock can be activated/deactivated pressing and holding down

the "Extra Load" and "Temp. °C" buttons for three second at the

same time, until an acoustic confirmation signal is heard.

When a button is pressed while the keypad lock function is active,

an acoustic warning will be heard and the three green LEDs will

flash.

Fast Freeze (Extra load)

Press the "Extra load" button before placing the food to be frozen

inside the freezer compartment.

When this function is active, the yellow LED is on and the three

green LEDs are off.

The function will automatically deactivate after 24 hours. It can also

be deactivated manually by pressing the same button.

When this function is not active, the yellow LED is off and the set

temperature is indicated by the green LEDs.

Acoustic alarm reset

To deactivate acoustic alarms

press and hold down the

"Extra Load" button for 3

seconds.

5019 308 01011

Whirlpool ART 769/NFV Program Chart

Brand: Whirlpool

Model: ART 769/NFV

Type: Program Chart

This manual is also suitable for

ART 766/NFV

Download PDF

report

Whirlpool ART 769/NFV Program Chart

This manual is also suitable for

Whirlpool ART 769/NFV Program Chart

Related papers

Other documents