USB Parallel Printer Adapter
1. Introduction :
The F5U002vea USB Parallel Adapter creates a bridge
between one USB port and one parallel port.
2. Features :
• Fully Compliant with USB Specification v1.1
• Supports Centronic 36 parallel Interface –
• Provides automatic support for IEEE 1284
compatibility, ECP mode and EPP mode.
3. System Requirements:
• PC system equipped with a free USB port
• Windows 98SE operating system or higher.
4. What comes with your F5U002vea:
• One Belkin Parallel Printer Adapter
• One driver disk
• One user’s manual
5. Hardware Installation:
• Plug the USB connector of the USB
Parallel Adapter into your PC.
• Connect the Centronic 36 pin male connector of
the USB Serial Adapter cable into the Centronic
36 pin female connector of the printer.