User Instructions
American DJ®
American DJ®
4295 Charter Street
Los Angeles, CA. 90058
www.americandj.com
Rev. 10/04
Reflex 300™ Introduction
Unpacking: Thank you for purchasing the Reflex 300™ by American
DJ®. Every Reflex 300™ has been thoroughly tested and has been
shipped in perfect operating condition. Carefully check the shipping
carton for damage that may have occurred during shipping. If the
carton appears to be damaged, carefully inspect your unit for damage
and be sure all accessories necessary to operate the unit have arrived
intact. In the event damage has been found or parts are missing, please
contact our toll free customer support number for further instructions.
Please do not return this unit to your dealer without first contacting
customer support at the number listed below.
Introduction: The Reflex 300™ is a unique multi-colored effects
fixture. The unit comes with two moving heads that operate indepen-
dently of each other. This unit creates multi-colored beams in a moon-
flower pattern. The unit has 3-way mode switch that allows the unit to
be operated in three different modes (see page 4 for operating modes).
To optimize beam intensity use this fixture with a fog machine or other
type of special effect smoke.
Customer Support: American DJ® provides a toll free customer
support line, to provide set up help and to answer any question should
you encounter problems during your set up or initial operation. You
may also visit us on the web at www.americandj.com for any com-
ments or suggestions. For service related issue please contact Ameri-
can DJ®. Service Hours are Monday through Friday 9:00 a.m. to 5:00
p.m. Pacific Standard Time.
Voice: (800) 322-6337
Fax: (323) 582-2610
To purchase parts online visit http://parts.americandj.com
Warning! To prevent or reduce the risk of electrical shock or fire, do
not expose this unit to rain or moisture.
Caution! There are no user serviceable parts inside this unit. Do not
attempt any repairs yourself, doing so will void your manufactures
warranty. In the unlikely event your unit may require service please
contact American DJ.
PLEASE recycle the shipping carton when ever possible.
©American DJ® - www.americandj.com - Reflex 300™ Instruction Manual Page 2
©American DJ® - www.americandj.com - Reflex 300™ Instruction Manual Page 4©American DJ® - www.americandj.com - Reflex 300™ Instruction Manual Page 3
Reflex 300™ Precautions
Safety Issues:
• To reduce the risk of electrical shock or fire, do not expose this
unit rain or moisture
• Do not spill water or other liquids into or on to your unit
• Do not attempt to operate this unit if the power cord has been
frayed or broken
• Do not attempt to remove or break off the ground prong from the
electrical cord. This prong is used to reduce the risk of electrical
shock and fire in case of an internal short
• This unit is intended for internal use only, use of this product out-
doors voids all warranties written or implied.
• Two Independent Moving Heads
• Easy Lamp Replacement
• Compact High-Tech Case Design
• Built-In Hanging Yoke
• Internal Microphone
• Multi-Colored Beams
• 3-Way Effects Switch - 3 Operating Modes
• Sound Active
• 2 x ZB-FCS 24v/150w Lamps
Reflex 300™ Features
Reflex 300™ Warranty Registration
The Reflex 300™ carries a one year (365 days) limited warranty.
Please fill out the enclosed warranty card to validate your purchase.
All returned service items whether under warranty or not, must be
freight pre-paid and accompany a return authorization (R.A.) num
-
ber. The R.A. number must be clearly written on the outside of the
return package. A brief description of the problem as well as the R.A.
number must also be written down on a piece of paper included in
the shipping
carton. If the unit is under warranty, you must provide a
copy of your proof of purchase invoice. You may obtain a R.A. num
-
ber by contacting our customer support team on our toll free custom
-
er support number. All packages returned to
the service department
not displaying a R.A. number on the outside of the package will be
returned to the shipper.
Reflex 300™ Operation
Power Supply: Before plugging your unit in, be sure the source
voltage in your area matches the required voltage for your American
DJ® Reflex 300™ before attempting operation.
General Operation: Just plug this light in, and watch it go. This fix-
ture is designed to operate as a stand alone unit. It has been tested
and the lamp has been installed at the factory there is no assembly
necessary. The Reflex 300™ is ready to be plugged in, out of the box.
There is no power switch, after plugging the unit in the unit will imme
-
diately begin to run to sound. Please note that tapping on the unit,
or high pitched sounds may not trigger the unit, the unit is designed
to react to low frequencies (bass). Also note that the music sensitiv
-
ity is preset at the factory and may not be changed or adjusted. The
fashion the unit will operate will depended on the mode setting, see
operating modes below.
Operating Modes: This unit comes with a 3-way multi-operating
switch located on the
bottom of the unit. The switch controls three
different sound-active operating modes.
Switch in the "I" position: Mode 1 - In this mode the two internal
dichroic colored glass dishes will rotate continuously regardless of an
audio source. The two external reflecting mirrors will only react to an
audio source via the units internal microphone.
Switch in the “O” position: Mode 2 - In this mode the two internal
dichroic colored glass dishes will remain static regardless of an audio
source. The two external reflecting mirrors will only react to an audio
source via the units internal microphone.
Switch in the “II” position: Mode 3 - In this mode both the two internal
dichroic colored glass dishes and the two external reflecting mirrors
will only react to an audio source via the units internal microphone.
Please carefully read and understand the instructions in this manual
thoroughly before attempting to operate this unit. These instructions
contain important safety information regarding the use and mainte
-
nance of this unit. Please keep this manual with the unit, for future
reference.
Reflex 300™ General Instructions
Reflex 300™ Breaker Reset & Lamp Replacement
Caution: Always replace with the exact same type lamp, unless oth-
erwise specified by an authorized American DJ
® technician. Replace
with anything other than the specified part can damage your unit and
will void your manufactures warranty.
Warning: If after you have replaced the lamp or reset the breaker
and you continue to blow either one, STOP using the unit. Contact
customer support for further instructions, you may have to return the
unit for servicing. Continuing to use the unit may cause serious dam
-
age.
Breaker Reset: This unit is equipped with a built-in safety breaker.
This breaker is designed to close the power circuit in the event of an
internal short or power surge. This will reduce the risk of electrical
shock or fire and protect the circuitry. To reset the breaker, push the
breaker button in until you hear it “pop” back in to place. If the break
-
er continues to pop, stop using the unit and contact our customer
support team, the unit may need to be returned for service
.
Lamp Replacement: Caution! Never open the unit when in use.
Always disconnect the main power and allow the fixture ample time
to cool before attempting to replace the lamp. Lamp replacement has
been made simple by incorporating a remove tray that is retained by
a single thumb screws. Again, please remember to always replace
with the exact same type lamp.
1. Be sure to follow the proper procedures when handling halogen
lamps. Never touch the new lamp with your bare fingers.
2. Unscrew the single thumb screw located on the rear of the unit.
3. Once the thumb screw has been remove, pull back the lamp
assembly cover plate to expose the lamps.
4. Remove and replace the lamp with an exact match.
5. Reassemble in reverse order.
©American DJ® - www.americandj.com - Reflex 300™ Instruction Manual Page 6©American DJ® - www.americandj.com - Reflex 300™ Instruction Manual Page 5
Halogen Lamp Warning! This fixture is fitted with
halogen lamps which are highly susceptible to dam
-
age if improperly handled. Never touch the lamps
with your bare fingers as the oil from your hands will
shorten lamp life. Also, never move the fixture until
the lamps have had ample time to cool. Remember,
lamps are not covered under warranty conditions.
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning the internal and exter-
nal lenses and dichroic colored dishes should be carried out periodi
-
cally to optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the out-
side casing.
2. Use a soft brush to clean out the cooling vents
3. Clean the external optics with glass cleaner and a soft cloth every
20 days.
4. Clean the internal optics with glass cleaner and a soft cloth every
30-60 days.
5. Always be sure to dry all parts completely before plugging the unit
back in.
Cleaning frequency depends on the environment in which the fixture
operates (I.e. smoke, fog residue, dust, dew). In heavy use we recom-
mend cleaning on a monthly basis. Periodic cleaning will ensure lon
-
gevity, and crisp beam output.
Reflex 300™ Cleaning
Trouble Shooting:
Listed below are a few common problems and solutions you should
try before contacting customer support. For all other issues please
contact customer support.
Unit rotates but has no light output from the unit;
1. Be sure you have connected your unit into a matching wall outlet.
2. Remove the lamp cover and be sure the lamps are seated in their
sockets properly. Occasionally lamps become loose during ship-
ping be sure the lamps are push in to their sockets all the way.
3. Be sure the lamps are good.
Heads do not rotate and lamps do not turn on;
1. Be sure you have connected your unit into a matching wall outlet.
2. Be sure the external breaker has not blown. The breaker is
located on the bottom panel of the unit.
3. Be sure the unit power cord is properly seated in the power outlet
and the outlet has power.
Reflex 300™ Trouble Shooting
©American DJ® - www.americandj.com - Reflex 300™ Instruction Manual Page 7
©American DJ®
American DJ® World Headquarters:
4295 Charter Street Los Angeles, CA 90058 USA
Tel: 323-582-2650 / Fax: 323-582-2610
Web: www.americandj.com / E-mail: [email protected]
Model: Reflex 300™
Voltage*: 120v~60Hz
Lamps: 2 x ZB-FCS 24v/150w
Breaker: 5 Amp
Dimensions: 14” H x 10” W x 13.5” D
Colors: Multi-Colored (7 Colors)
Effect: 3 User Operating Modes
Weight: 9 Lbs.
Warranty: 1 Year (365 Days)
* Voltage is preset at the factory and is not user selectable.
Please Note: Specifications and improvements in the design
of this unit and this manual are subject to change without any
prior written notice.
Reflex 300™ Specifications
ONE YEAR LIMITED WARRANTY
A. American DJ® hereby warrants, to the original purchaser, American DJ® products to be
free of manufacturing defects in material and workmanship for a period of one year (365
days) from the date of purchase. This warranty shall be valid only if the product is pur
-
chased within the United States of America, including possessions and territories. It is the
owner’s responsibility to establish the date and place of purchase by acceptable evidence,
at the time service is sought.
B. For warranty service, send the product only to the American DJ® factory. All shipping
charges must be pre-paid. If the requested repairs or service (including parts replacement)
are within the terms of this warranty, American DJ
® will pay return shipping charges only
to a designated point within the United States. If the entire instrument is sent, it must be
shipped in its original package. No accessories should be shipped with the product. If any
accessories are shipped with the product, American DJ
® shall have no liability whatsoever
for loss of or damage to any such accessories, nor for the safe return thereof.
C. This warranty is void if the serial number has been altered or removed; if the product is
modified in any manner which American DJ
® concludes, after inspection, affects the reli-
ability of the product; if the product has been repaired or serviced by anyone other than
the American DJ
® factory unless prior written authorization was issued to purchaser by
American DJ®; if the product is damaged because not properly maintained as set forth in
the instruction manual.
D. This is not a service contract, and this warranty does not include maintenance, cleaning
or periodic check-up. During the period specified above, American DJ
® will replace defec-
tive parts at its expense, and will absorb all expenses for warranty service and repair labor
by reason of defects in material or workmanship. The sole responsibility of American DJ®
under this warranty shall be limited to the repair of the product, or replacement thereof,
including parts, at the sole discretion of American DJ
®. All products covered by this war-
ranty were manufactured after January 1, 1990, and bear identifying marks to that effect.
E. American DJ® reserves the right to make changes in design and/or improvements upon
its products without any obligation to include these changes in any products theretofore
manufactured.
F. No warranty, whether expressed or implied, is given or made with respect to any acces
-
sory supplied with products described above. Except to the extent prohibited by applicable
law, all implied warranties made by American DJ
® in connection with this product, includ-
ing warranties of merchantability or fitness, are limited in duration to the warranty period
set forth above. And no warranties, whether expressed or implied, including warranties of
merchantability or fitness, shall apply to this product after said period has expired. The
consumer’s and or Dealer’s sole remedy shall be such repair or replacement as is expressly
provided above; and under no circumstances shall American DJ® be liable for any loss or
damage, direct or consequential, arising out of the use of, or inability to use, this product.
G. This warranty is the only written warranty applicable to American DJ® Products and
supersedes all prior warranties and written descriptions of warranty terms and conditions
heretofore published.
H. Lamps are not covered under this or any other warranty either written or implied.
Reflex 300™ Warranty
-
1
-
2
-
3
-
4
Anycom PM-300 User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
ADJ Flash Beam User manual
-
American DJ UV Panel HP User Instructions
-
-
-
-
-
-
-
-