2. Home
  3. Lighting
  4. Floodlights
  5. Westinghouse
  6. 0373900

Westinghouse 0373900 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Westinghouse 0373900 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Westinghouse Lighting, Philadelphia, PA 19154-1029, U.S.A.
www.westinghouselighting.com
, WESTINGHOUSE, and INNOVATION YOU CAN BE SURE OF
are trademarks of Westinghouse Electric Corporation.
Used under license by Westinghouse Lighting.
All rights reserved.
Made in China
INSTALLATION GUIDE
Please read all information before installing the lamps and keep this sheet for future reference.
• These lamps are direct replacements for T8 lamps.
• Also dimmable when used with compatible dimming ballast
• Operates on Most Instant Start and Many Programmed Rapid Start Electronic Ballasts.
• Risk of Fire: Do not install this lamp in a preheat luminaire.
• Risk of electronic shock - Use only in dry locations.
• Any modications to this product will void the warranty.
• This lamp may not be compatible with all ballasts, go to www.westinghouselighting.com for compatibility information.
IMPORTANT SAFETY INFORMATION:
CAUTION: If the lamp or luminaire exibits undesireable operation (buzzing, ickering etc.), immediately turn o power, remove lamp from
luminaire and contact us at www.westinghouselighting.com.
Risk of re. Do not install in a pre-heat luminaire.
This lamp only operates on electronic ballasts. If lamp does not light when the luminaire is energized, remove lamp from luminaire and contact us at
www.westinghouselighting.com or qualied electrician.
This device is not intended for use with emergency exit xtures or emergency exit lights.
Lamps must be operated within an ambient xture temperature of -22
o
F and 133
o
F to ensure UL compliance.
INSTALLATION INSTRUCTIONS
Turn o the power to the
luminaire before removing
the lamp.
STEP 1. STEP 2. STEP 3A. STEP 3B.
STEP 4A. STEP 4B. STEP 5. STEP 6.
Remove the diuser, lens
cover or louver (if provided).
Fluorescent lamps to be
replaced with Westinghouse
TLED T8 lamps are shown
above.
Remove the uorescent lamp.
First, rotate the lamp 90°
degrees.
Then, remove the lamp from
the lamp holder.
Insert the Westinghouse LED
replacement lamp.
NOTE: Please insert lamp per
“SIDE UP” label direction (on
lamp base) to make sure the
light-producing side of the
LED tube is facing downwards.
Then, rotate the lamp 90°
degrees.
Make sure that the pins are
completely seated in the
lamp holders. One LED
lamp for each uorescent
lamp removed.
Repeat steps 3 and 4 as
needed for additional lamps.
Replace the diuser, lens
cover or louver (if removed in
step 2).
Turn the power to the
luminaire back on.
ES-WH-015
/