Welcome

Welcome to Sytech! Thank you for purchasing the new Cordless Kettle SY-HV30. To enjoy all the features of this

cordless kettle, read this manual carefully. To prevent damage or injury, always follow the safety instructions in this

manual.

Important Safeguards

 It is important to read this manual before using the kettle for the first time.

 Make sure the appliance is unplugged when not in use. Only insert the plug into an outlet current, do not use

extensions or multiple sockets, as this may cause an overload in the circuit.

 Be sure to fill the water in the kettle and then connect it to the mains.

 Keep the power cord plugged into an earthed switch during use.

 Be sure to close the lid before using the kettle.

 WARNING: Never open the lid when the water is boiling.

 The automatic safety will protect the kettle from damage caused by overheating.

 If the kettle is functioning without water, immediately remove the plug from the outlet and then pour cold water

to cool the base down. The safety switch will reset itself.

 If your outlet is damaged or loose, the appliance may overheat. If this occurs, please contact the Service

 When using the appliance, always pay attention to the water level mark the outside of the kettle.

 Do not allow the water level is below the minimum level and never exceed the maximum level.

 If the power cord is damaged, the appliance malfunctions, or other accessories are broken /

contact the Service Center Sytech. Never try to handle the product yourself, as this may void the warranty.

 Always store in a safe, dry place when you are not using the device

Caution:

 Do not force the "ON / OFF" button or return to the "ON" position when the kettle disconnects automatically as

this process can damage the kettle and heating element.

General Description of the SY-HV30

Safety Instructions

 The boiler will only turn on or off with the ON / OFF button. Never turn on the kettle before positioning it on the

base

 This appliance is designed for domestic use only.

 Never allow the base or bottom of the kettle to get in contact with water. Do not immerse the Kettle or the base

in water. If this event occurs, contact the Sytech Repairs Center before reuse.

 To comply with safety regulations and to avoid hazards, repairs of Electrical equipment

must be performed by qualified personnel. If a repair is necessary, please contact Sytech service center.

 DO NOT operate the appliance if:

o The appliance or the power cord are damaged

o The appliance has been dropped.

 Always remove the plug from the wall socket:

 If there is no water inside the kettle, do not turn the kettle on.

 This appliance is not intended for use by persons (including children) with reduced physical, sensory or

mental capabilities, or lack of experience and knowledge, unless they have been given supervision or

instructions concerning use of the appliance by a person responsible for their safety.

 WARNING: Never open the lid while the water is boiling.

Operation Guidelines

Before the first use

• Place the heating base on a firm and uniform surface

• Pour the desired amount of water into the kettle and make sure the lid is closed properly. The water level

can be measured by the level mark on the exterior of the appliance. Once the appliance is functioning, do

not touch any part other than the handle.

• Place the kettle carefully onto the base.

• Insert the plug into the wall socket.

• Turn on the appliance to start the heating process, the indicator lamp will turn on showing that the

appliance is functioning.

• As soon as the water has boiled, the appliance will switch off automatically. If a lower water temperature is

desired, the appliance can be switched off manually as well.

• In such cases, unplug the appliance and reuse it after 15-20 seconds.

Decalcifying

• If the appliance switches off before reaching boiling point, it is a sign that decalcifying is needed.

• Any regular de-scaling agent may be used, provided that the relevant instructions are observed.

• To clean the kettle thoroughly after decalcification, let it go through several boiling cycles using clean

water each time. Rinse the kettle with clean water afterwards and let it dry before re-use.

Cleaning and care

Cleaning the appliance and its parts is easiest immediately after use.

before cleaning the kettle.

Specifications

• Voltage: 220-240V. 50-60Hz.

• Power output: 1850-2200W.

• Water tank capacity: 1.7 litre

• Cable length: 0,95M.

• Power source: 220-240V.-50Hz.

Declaration of Conformity

Manufacturer Name: Satyatrade S. L.

Address: Pol.Ind.La Raya. C/ Guadalquivir, 2.

Sytech® SY-HV30 complies with the following directives:

CE Standard: Directive 2004/108/EC

ROHS Standard: 2002/95/EC Restriction of Hazardous Substances

Signed: Ajeet Nebhwani Utamchandani

Sole Administrator