Waeco PP500 Operating instructions

PerfectPower PP500

D 3 GTWechselrichter

Bedienungsanleitung

GB 7 CInverter

Instruction Manual

E 11 Convertidor de ondas seno

Instrucciones de uso

F15Onduleur

Notice d’emploi

I 19 Invertitore

Istruzioni per l’uso

NL 23 GInverter

Gebruiksaanwijzingen

DK 27 SVekselretter

Betjeningsanvisning

S 31 TVäxelriktare

Bruksanvisning

N 35 SVekselretter

Bruksanvisning

FIN 39 Tahdistettu vaihtomuunnin

Käyttöohjeet

titelseite_neu_a5.fm Seite 1 Donnerstag, 29. September 2005 3:50 15

2

Collected_MB-840.qxd 24/06/03 13:03 Page 2

Page is loading ...

6

Collected_MB-840.qxd 24/06/03 13:03 Page 6

7

Read these instructions before you start with the commissioning of the inverter.

Failure in observing these warnings may result in injuries to persons or damage to

materials.

General safety and installation instructions

Warning! The following fundamental safety

measures must be observed when using

electrical equipment to avoid danger of:

- electric shocks

- danger of fire

- injuries

About the unit itself

- Do not connect the 230 volts output from the

inverter with another 230 volts source.

- The inverter must only be used for the purpose

specified by the manufacturer!

- When working on the inverter, always

disconnect it from the mains!

- Even after triggering the safety device (fuse),

parts of the inverter still carry voltage!

- Do not operate the inverter if the housing or

cables are damaged!

- Maintenance and repair must only be carried

out by a qualified specialist who is familiar

with the dangers involved and aware of the

relevant regulations!

- The inverter must not be exposed to heat

sources (solar radiation, heating etc.) for to

avoid additional heating-up.

- The inverter must be kept in a safe place out of

the reach of children!

- Air inlet and outlets must not be covered.

- Ensure proper ventilation!

- The inverter may not be operated in a damp or

wet environment!

- The inverter must be positioned and secured

safely in order to avoid it being knocked over or

it falling down!

Caution when installing on boats!

- Wrong installation of electrical units on boats will

lead to corrosion of the boat. Therefore, please

let a (boat) electrician carry out the installation

of the inverter.

Electrical wires:

- If cables have to be led through metal walls or

other sharp-edged walls, use a cable duct or

cable bushes!

- Do not lay cables loose or in sharp bends on

electricity conducting materials (metal)!

- Do not pull on cables!

- Do not lay 230 V mains cable and 12/24 V DC

cable together into the same cable conduit

(cable duct)!

- Secure cables properly!

- When laying the cable, make sure there is no

danger of tripping over and of the cable being

damaged!

Intended use of the inverter

The inverters can be operated everywhere that a 12 V DC battery (for 840-012PP) or a 24 V DC

battery (for 840-024PP) is present. An increase in heat can develop at some units due to the non-sine-

shaped voltage. The maximum continuous rating amounts to 400 watts at the inverters 840-012PP and

840-024PP. Units with a higher power demand must not be connected.

Reference! It must be observed when installing units with electrical drive (e.g. power drill, refrigerator

etc.) that they often need higher capacity than indicated on the type plate.

Scope of delivery

1. Inverter

2. connecting cable with battery terminals

3. operating instructions

Collected_MB-840.qxd 24/06/03 13:03 Page 7

8

The start-up can be done with the “ON/OFF”

switch. The green control light-emitting diode

“POWER” lights up in the switch position “ON”.

Should the battery voltage falls below 10.7/21.4 V

during operation, an audible signal is emitted and

the red control light-emitting diode illuminates.

The inverter switches off if the battery voltage

drops further. When the heating is too strong, the

inverter switches off — the red control light-

emitting diode illuminates. Switch off the inverter

by means of the “ON/OFF“-switch. The inverter

can be switched on again after it has cooled

down. When operating the inverter during

longer period of time and with the largest load, it

is recommendable to start the motor in order to

recharge the battery of the vehicle. The inverter

can be operated with the motor running or

switched off. However, the motor should not be

started if the inverter is switched on.

Preparation and connection of the inverter

Commissioning of the inverter

Unscrew red knurl nut (6) and fasten the ring

eye (10) of the red connecting cable.

Unscrew black knurl nut (7) and fasten the

ring eye (11) of the black connecting cable.

To start-up the inverter, connect the red

terminal (+) with the positive pole (+) of the

battery and the black terminal (-) with the

negative pole (-) of the battery.

Make sure that the poles are clean when

connecting the battery.

1 230 V AC output

2 ”ON/OFF” control light-emitting diode

green

3 ON/OFF Switch

4 control light-emitting diode red

(overload- and undervoltage display)

5 Ventilator

6 Positive contact (red knurl nut)

7 Negative contact (black knurl nut)

8 Positive contact (red terminal)

9 Negative contact (black terminal)

10 Red ring eye

11 Black ring eye

Caution! Length and cross-section of the

connecting cable are synchronized to each

other! Do not modify without authorisation.

Make sure that the polarity will not be

exchanged! Reverse polarity connection will

blow the internal fuses. Exchange of fuses by

experts only!

1 2 3 4

5 6 7

8 9 10 11

Collected_MB-840.qxd 24/06/03 13:03 Page 8

9

Error detection

Error

No output voltage

Alarm tone during the operation

Unit switches On/Off cyclically

The inverter switches off when

the power consuming unit is

switched on.

Cause

Battery voltage is smaller than

10 V (840-012PP)

or 20 V (840-024PP)

Thermal overload

Fuse is defective (in the inverter

or in the vehicle)

Battery voltage is under

10.7 V (840-012PP)

or 21.4 V (840-024PP)

Poor contact at the battery with

load

Permanent load is too high

Switch-on current is too high

Troubleshooting

Load battery (start motor)

Switch off power consuming unit

let inverter cool down and

provide for better ventilation

Fuse to be replaced by a

qualified electrician

Charge battery

Cleaning the contacts

Reduce load

Comparison of the unit capacity

with the maximum capacity of

the inverter

Technical data

Article No. 840-012PP 840-024PP

Input nominal voltage: 10V~15V+/-0.3V 20V~30V+/-0.6V

Permanent output capacity (>4 hrs.): 400 W 400 W

Permanent output capacity (30 min.): 500 W 500 W

Peak output capacity (0.1 sec.): 1000 W 1000 W

Output voltage 210-230 V AC 210-230 V AC

Output frequency: 50 Hz 50 Hz

Efficiency with nominal output: 90 % 90 %

No-load current consumption: <0.15 A <0.15 A

Maximum ambient temperature: 40°C 40°C

Dimensions W x H x D: 105 x 57 x 225 mm 105 x 57 x 225 mm

Weight 1.2 kg 1.2 kg

Subject to changes due to technical progress and availability.

vorbehalten.

Reference! The output voltage of this rectangle inverter can be measured only correctly with an analog

indicator (pointer instrument).

If you have further questions about the inverter, please contact:

Collected_MB-840.qxd 24/06/03 13:03 Page 9

10

Collected_MB-840.qxd 24/06/03 13:03 Page 10

Page is loading ...

14

Collected_MB-840.qxd 24/06/03 13:03 Page 14

Page is loading ...

18

Collected_MB-840.qxd 24/06/03 13:03 Page 18

Page is loading ...

22

Collected_MB-840.qxd 24/06/03 13:03 Page 22

Page is loading ...

26

Collected_MB-840.qxd 24/06/03 13:03 Page 26

Page is loading ...

30

Collected_MB-840.qxd 24/06/03 13:03 Page 30

Page is loading ...

34

Collected_MB-840.qxd 24/06/03 13:03 Page 34

Page is loading ...

38

Collected_MB-840.qxd 24/06/03 13:03 Page 38

Page is loading ...

42

Collected_MB-840.qxd 24/06/03 13:03 Page 42

43

Collected_MB-840.qxd 24/06/03 13:03 Page 43

Europe

WAECO Schweiz AG

Riedackerstrasse 7a

CH-8153 Rümlang (Zürich)

℡ +41 44 8187171

 +41 44 8187191

Mail: info@waeco.ch

WAECO Danmark A/S

Tværvej 2

DK-6640 Lunderskov

℡ +45 75585966

 +45 75586307

Mail: waeco@waeco.dk

WAECO Ibérica S.A.

Camí del Mig, 106

Poligono Industrial Les Corts

E-08349 Cabrera de Mar

(Barcelona)

℡ +34 93 7502277

 +34 93 7500552

Mail: info@waeco.es

WAECO Distribution SARL

ZAC 2 · Les Portes de L‘Oise

Rue Isaac Newton – BP 59

F-60230 Chambly (Paris)

℡ +33 1 30282020

 +33 1 30282010

Mail: info@waeco.fr

WAECO Finland OY

Mestarintie 4

FIN-01730 Vantaa

℡ +358 20 7413220

 +358 9 7593700

Mail: waeco@waeco.fi

WAECO Italcold SRL

Via dell’Industria 4/0

I-40012 Calderara di Reno (BO)

℡ +39 051 727094

 +39 051 727687

Mail: [email protected]

WAECO Norge AS

Leif Weldingsvei 16

N-3208 Sandefjord

℡ +47 33428450

 +47 33428459

Mail: firmapost@waeco.no

WAECO Benelux B.V.

Ecustraat 3

NL-4879 NP Etten-Leur

℡ +31 76 5029000

 +31 76 5029090

Mail: [email protected]

WAECO Svenska AB

Gustaf Melins gata 7

S-42131 Västra Frölunda

(Göteborg)

℡ +46 31 7341100

 +46 31 7341101

Mail: [email protected]

WAECO UK Ltd.

Dorset DT2 8LY · Unit G

Roman Hill Business Park

UK-Broadmayne

℡ +44 1305 854000

 +44 1305 854288

Mail: [email protected]

CH

DK

E

F

FIN

I

N

NL

S

UK

Overseas + Middle East

WAECO Pacific Pty. Ltd.

1 John Duncan Court

Varsity Lakes QLD 4227

℡ +61 7 55076000

 +61 7 55076001

Mail: [email protected].au

WAECO Impex Ltd.

Suites 3210-12 · 32/F · Tower 2

The Gateway · 25 Canton Road

Tsim Sha Tsui · Kowloon

Hong Kong

℡ +852 24632750

 +852 24639067

Mail: [email protected]

WAECO Impex Ltd.

Taipei Office

2 FL-3 · No. 56 Tunhua South Rd, Sec 2

Taipei 106, Taiwan

℡ +886 2 27014090

 +886 2 27060119

Mail: marketing@waeco.com.tw

WAECO Middle East FZCO

R/A 8, SD 6

Jebel Ali, Dubai

℡ +971 4 8833858

 +971 4 8833868

Mail: waeco@emirates.net.ae

WAECO USA, Inc.

8 Heritage Park Road

Clinton, CT 06413

℡ +1 860 6644911

 +1 860 6644912

Mail: [email protected]

AUS

HK

ROC

UAE

USA

Headquarters

WAECO International GmbH · Hollefeldstraße 63 · D-48282 Emsdetten

℡ +49 2572 879-195 ·  +49 2572 879-322 · Mail: [email protected] · Internet: www.waeco.de

D

www.waeco.com

3.03.18.01435 05/2007

adresse_A5_09.fm Seite 2 Freitag, 21. Juli 2006 2:51 14

Waeco PP500 Operating instructions

This manual is also suitable for

Waeco PP500 Operating instructions

in other languages

Related papers

Other documents