GB
Art. 60083 13
For use
Functions
The aroma diffuser is a modern fragrance diffuser which uses ultrasound technology to generate a
ne mist and thus distribute the fragrance throughout the whole room. The aroma diffuser has the
following additional function:
■ LED: LEDs are integrated into the aroma diffuser which either light up in the selected colour or
change colour automatically.
Device and controls
1
Marking for maximum lling quantity (100 ml) [g. C]
2
Operating button [g. F/G]
3
Adaptor [g. F]
The aroma diffuser is controlled using one operating button
2
on the bottom side of the device.
This button can be used to switch the aroma diffuser on and off. You can only switch on when the
water tank is correctly lled (max. lling quantity 100 ml
1
). In addition, the button can be used to
dene the colour of the LED lighting. The following settings are available:
Device on → automatic colour change → single colour→ LED off→ device off
Filling the water tank with water and aroma essence
Fill the water tank with max. 100 ml fresh drinking water and add some drops of the aroma essence
(depending on the desired intensity) to the water.
ATTENTION! Make sure that the device is operated on a surface which is resistant to water, and
that it cannot tip over. In particular, when operated with mineralised water, condensation / residues
may be produced. Make sure that the mist being issued is not directed towards electronic appliances,
furniture or walls.
Cleaning and servicing
■ Before cleaning, pull the mains plug.
■ Empty the device after each use and dry the water tank with a cloth.
■ Wash the water tank with clear water when you wish to change the aroma. This prevents mixing
different aromas.
■ Only clean the outside of the device with a soft, slightly damp cloth. Then rub it dry with a soft, dry
cloth.
■ Do not under any circumstances us brushes, sharp cleaning implements, benzene, thinners or
alcohol.
Descaling
Descale the device after ve or six uses or every 14 days. To do so, proceed as follows:
1. Disconnect the device from the power supply.
2. Fill the water tank with a maximum of 100 ml of water and add three tablespoonfuls of citric acid.
3. Allow the liquid to take effect for at least fteen minutes.
4. Empty out the liquid.
5. Wipe out the water tank with a dry cloth.
However, if you have any questions, please contact our service department. The service department
address is included on the separate supplementary sheet.