I
T
I
T
egaPstnetno
2noitcudort
4seton yreviled laren
4seton ytef
ick start 5
6slortnoc fo noitpircs
21elbaT emmargo
41rotceles emmargo
71 reward tnegret
81esu ot stnuoma dna sdia gnihsaw ,stnegret
02resu eht rof ecivda lufe
12hsaw niam e
32ecnanetniam enituor dna gninae
52snoitcnuflam gnitagitsev
72atad lacinhc
tting up + installation 28
BEFORE SWITCHING ON THE APPLIANCE MAKE SURE
IT IS CORRECTLY INSTALLED AND THAT THE FIXING
SCREWS ARE REMOVED AS SHOWN IN PAGE 28.
ARNING: water may reach very high temperatures during
the wash cycle.
12hsaw niam ehT
32ecnanetniam enituor dna gninaelC
52snoitcnuflam
nita
itsevnI
–
After installation, the appliance must be positioned so that the plug
is accessible.
–
–
–
–
–
–
Please do not use converters, multiple sockets or extension cords.
Make sure there is no water in the drum before opening the
porthole.
Do not pull on the power cord or appliance to unplug the machine.
Do not expose the washing machine to rain, direct sunlight or other
weather elements.
When moving, do not lift the washing machine by the knobs or
detergent drawer; during transport, never rest the porthole on the
trolley. We recommend two people lift the washing machine.
In the event of fault and/or malfunction, turn off the washing
machine, close the water faucet and do not tamper with the
appliance. Immediately contact the Customer Service Centre
and only use original spare parts. Failure to observe these
instruction may jeopardise appliance safety.
–
–
–
–
To consult the product fiche please refer to the manufacturer
website.
The maximum load capacity of dry clothes depends on the model
used (see control panel).
Before cleaning or maintaining the washing machine, unplug the
appliance and turn off the water faucet.
Make sure the electrical system is grounded. Otherwise, seek
qualified ed professional assistance.
Safety instructions
WARNING: water may reach very high temperatures during
the wash cycle.
By placing the mark on this product, we are con rming
compliance to all relevant European safety, health and
environmental requirements which are applicable in legislation
for this product.
3
–
For the installation of built in appliances, please look at the specific
paragraph.
I
T
I
T
2noitcudort
4seton yreviled laren
4seton ytef
ick start 5
6slortnoc fo noitpircs
21elbaT emmargo
41rotceles emmargo
71 reward tnegret
81esu ot stnuoma dna sdia gnihsaw ,stnegret
02resu eht rof ecivda lufe
12hsaw niam e
32ecnanetniam enituor dna gninae
52snoitcnuflam gnitagitsev
72atad lacinhc
tting up + installation 28
BEFORE SWITCHING ON THE APPLIANCE MAKE SURE
IT IS CORRECTLY INSTALLED AND THAT THE FIXING
SCREWS ARE REMOVED AS SHOWN IN PAGE 28.
ARNING: water may reach very high temperatures during
the wash cycle.
12hsaw niam ehT
32ecnanetniam enituor dna gninaelC
52snoitcnuflam
nita
itsevnI
–
After installation, the appliance must be positioned so that the plug
is accessible.
–
–
–
–
–
–
Please do not use converters, multiple sockets or extension cords.
Make sure there is no water in the drum before opening the
porthole.
Do not pull on the power cord or appliance to unplug the machine.
Do not expose the washing machine to rain, direct sunlight or other
weather elements.
When moving, do not lift the washing machine by the knobs or
detergent drawer; during transport, never rest the porthole on the
trolley. We recommend two people lift the washing machine.
In the event of fault and/or malfunction, turn off the washing
machine, close the water faucet and do not tamper with the
appliance. Immediately contact the Customer Service Centre
and only use original spare parts. Failure to observe these
instruction may jeopardise appliance safety.
–
–
–
–
To consult the product fiche please refer to the manufacturer
website.
The maximum load capacity of dry clothes depends on the model
used (see control panel).
Before cleaning or maintaining the washing machine, unplug the
appliance and turn off the water faucet.
Make sure the electrical system is grounded. Otherwise, seek
qualified ed professional assistance.
Safety instructions
WARNING: water may reach very high temperatures during
the wash cycle.
•
;
•
2004/108/EC (EMC);
•
2009/125/EC (ErP);
•
2011/65/EU (RoHS)
and subsequent amendments.
By placing the mark on this product, we are con¿ rming
compliance to all relevant European safety, health and
environmental requirements which are applicable in legislation
for this product.