Legrand RH703PTUTCCCV4 User guide

Legrand
Brand
Legrand
Model
RH703PTUTCCCV4
Type
User guide
radiant
®
Tru-Universal
SETUP QUICKSTART GUIDE
HOW TO:
- Run Autocalibration
- Change to Reverse Phase
- Adjust High End Trim
- Adjust Low End Trim
- Disable Autocal
- Set to MLV Mode
AUTOCALIBRATION
INDICATOR LED
(will fl ash to indicate changes)
TOP OF DIMMER
FORWARD/REVERSE
PHASE SWITCH F/R
ON/OFF PADDLE
SLIDER
(shown in MIN setting)
CALIBRATION BUTTON CAL
(Push button that can be invoked with
a pen or small screwdriver)
TO RUN AUTO CALIBRATION FEATURE ON DIMMER:
Press Calibration Button
Dimmer will Auto Confi gure
Dimmer is now Calibrated
REVERSE PHASE
TO CHANGE TO REVERSE PHASE:
Set F/R Switch to R*
Press and Release
Calibration Button
Dimmer is now Calibrated
Dimmer will Auto Confi gure
*To switch back to forward phase move the switch to F and recalibrate.
HIGH END TRIM
INDICATOR LED
(will fl ash to indicate changes)
TOP OF DIMMER
FORWARD/REVERSE
PHASE SWITCH F/R
ON/OFF PADDLE
SLIDER
(shown in MIN setting)
CALIBRATION BUTTON CAL
(Push button that can be invoked with
a pen or small screwdriver)
TO ADJUST HIGH END TRIM:
Move Slider up to Full On
Press and Hold CAL
for ~ 5 Seconds
Adjustment Saved
LED will Blink, Release CAL
Push CAL 12x to Cycle
through Adjustments
Move Slider Down when
at Desired Setting
LOW END TRIM
TO ADJUST LOW END TRIM:
Move Slider Down to MIN
Press and Hold CAL
for ~ 5 Seconds
Adjustment Saved
LED will Blink, Release CAL
Push CAL 12x to Cycle
through Adjustments*
Move Slider Up when
at Desired Setting
*Some LED’s should not be set at their lowest setting. While they may be able to dim to
that level after being on, they may not turn on to that level.
INDICATOR LED
(will fl ash to indicate changes)
TOP OF DIMMER
FORWARD/REVERSE
PHASE SWITCH F/R
ON/OFF PADDLE
SLIDER
(shown in MIN setting)
CALIBRATION BUTTON CAL
(Push button that can be invoked with
a pen or small screwdriver)
MLV MODE
TO PUT DIMMER INTO MLV MODE:
Move Slider up to Full On
Press and Hold CAL
for ~ 5 Seconds
Dimmer now in MLV Mode
***
LED will Blink, Release CAL
Press and Hold CAL
for ~ 10 Seconds
LED Blink will Change
to 2x per Second
Move Slider Down
***To switch out of MLV mode repeat these steps.
DISABLE AUTOCAL
TO DISABLE AUTOCAL AT POWER UP:
Move Slider Down to MIN
Press and Hold CAL
for ~ 5 Seconds
LED will Blink, Release CAL
Push CAL 12x to Cycle
through Adjustments*
Autocal Disabled
Press and Hold CAL for ~10
Seconds at Desired Setting
**
LED will STOP Blinking
* See low end trim.
** Low end trim adjustments must be made before disabling autocal, at least one adjustment needs to be made.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Legrand RH703PTUTCCCV4 User guide

Legrand
Brand
Legrand
Model
RH703PTUTCCCV4
Type
User guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents