DELUXE POWER TOWER
Model PT 675-E
CAUTION:
WARNING: Do not use this
product without a physician’s
approval.
Do not let children use this
product unsupervised.
Read all instructions carefully
before using.
Tighten all bolts before using
1
Owner’s Manual Version:1202
Photo may differ from actual product
Tighten all bolts before using
equipment.
Leave adequate space to exercise
Questions/ Comments
PLEASE DO NOT CONTACT THE
STORE
Elite Fitness is committed to
providing the very best of quality
and customer satisfaction for all of
the products we distribute. If for
any reason , you are dissatisfied
with the product you have
purchased or need assistance in
any way, please do not hesitate to
contact our knowledgeable support
staff at: 623-888-6379
Mon.-Fri 9:00 am – 5:00 pm Mountain Time
CAUTION:
Maximum Weight Limit is 250 lbs.
BEFORE BEGINNING ASSEMBLY…
Take a few moments to familiarize yourself with the specific parts and hardware included with your
product. Make sure all the parts and hardware are included in the carton and examine them for any
damage that may have occurred in transport. Some parts may be pre-assembled and pre-installed.
CAUTION
WARNING:
Before starting any exercise program, consult your physician.
Read all instructions very carefully before using equipment
Tighten all bolts securely before using equipment
Product Warranty
Limited Liability
Elite Fitness warrants that this product will be free from defects in materials and workmanship for a period
of 90 days from date of purchase. This warranty applies only to the original purchaser when purchase of
the product is from an authorized retailer and is for personal or household use, but not when the sale is for
commercial use. This warranty is not transferable.
2
EXCEPT FOR THE LIMITED EXPRESS WARRANTY STATED HEREIN, Elite Fitness DISCLAIMS ALL
OTHER EXPRESS OR IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. SOME
STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE
ABOVE LIMITATIONS MAY NOT APPLY TO YOU.
Elite Fitness, will not be liable for any loss or damage, including incidental or consequential damages of
any kind, whether based upon warranty, contract or negligence and arising in connection with the sale, use
or repair of the product.
SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO
YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY HAVE OTHER
RIGHTS THAT VARY FROM STATE TO STATE.
In the event of failure of this product to conform to this warranty during the warranty period, please call Elite
Fitness Customer Service Number at 623-888-6379 for assistance in the repair or replacement of the
product or any covered part. Elite Fitness will repair or replace, at its own option, the product or any
covered part, except that this warranty does not cover damage caused by accident ( including transit) , or
repairs or attempted repairs by any person not authorized by Elite Fitness, or by vandalism, misuse, abuse,
or alteration. The Warranty Period is based on the purchase date of the product validated by the
Authorized Retailers Register Receipt, or valid copy of transaction statement.
If you require service under this warranty, please call Customer Service at 623-888-6379 or visit our web
site at: www.extremeproductsgroup.com
PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE
Parts List
Part No. Description Qty. Part No. Description Qty.
1L Left Base Frame 1 20 50mm Upright Post End Cap 2
1R Right Base Frame 1 21 M10*62mm Carriage Bolt 4
2 Stabilizer 1 22 M8*60 Carriage Bolt 4
3 Diagonal Support (L/R) 2 23
M10x68 Hexagon Pan Head
Screw 4
4 Lower Upright Post (L/R) 2 24
M8x65 Hexagon Pan Head
Screw 16
5 Upper Upright Post (L/R) 2 25
M8x40 Hexagon Pan Head
Screw 5
6 Left Dip Support 1 26
M6x40 Hexagon Pan Head
Screw 2
7 Right Dip Support 1 27 30x60mm Square End Cap 1
3
8 Vertical Handle 2 28 20x10.5x1.5mm Arc Washer 12
9 Chin-up Bar 1 29 20x8.5x1.5 mm Arc Washer 26
10 Cross Bar 1 30 16x8.5x1.5mm Washer 3
11 Backrest Pad 1 31 13x6.5x1mm Washer 2
12 Arm Pad 2 32 M10 Lock Nut 8
13
50mm Base Frame
Adjustment End Cap 2 33 M8 Lock Nut 16
14
50mm Base Frame Round
End Cap 2 34 M6 Lock Nut 2
15 6 Grip 6 35 ø26*ø8.5*1.5 Arc Washer 8
16 4 2/5″ Grip 2 36 6# Hexagonal Socket Wrench 1
17 5 1/5’’ Foam 2 37
13#17# Convex Hexagonal
Wrench 1
18 25mm Round Cap 10
19 50mm Sleeve 2
Exploded View
4
ASSEMBLY INSTRUCTIONS
Step 1
Connect the Left and Right Base Frame (#1L & #1 R) with the Mid-
Stabilizer (#2), Secure each end with two M8 Hexagon Pan Head
Screws (#24), four Arc Washers (#35) and two M8 Lock Nuts (#33).
NOTE: Tighten the Nuts and Bolts at this time.
Step 2
Attach the Left Lower Upright Post (#4)
onto the Left Base Frame (#1L), secure it
Left Angle
Right Angle
5
onto the Left Base Frame (#1L), secure it
with two M10 Carriage Bolts（#21）, two
Arc Washers (#28) and two M10 Lock
Nuts (#32).
NOTE: Do Not tighten the nuts and bolts
yet.
Attach the Left Diagonal Support (#3) to
the Left Base Frame (#1L) and the Left
Lower Upright Post (#4), secure it to the
Left Base Frame with two M8 Carriage
Bolts(#22), two Arc Washers (#29) and
two M8 Lock Nuts(#33). Secure it to the
Left Lower Upright Post(#4) with two M8
Hexagon Pan Head Screws(#24), four
Arc Washers (#29) and two M8 Lock
Nuts(#33).
Repeat to install the Right side.
Left AngleRight Angle
NOTE: Do Not Tighten all the Nuts and Bolts at this time.
ASSEMBLY INSTRUCTIONS
Step 3
Attach two Upper Upright Posts (#5) to the two Lower Upright Posts (#4).
Connect the two Upper Upright Posts(#5) with the Cross Brace (#10) with
four M8 Hexagon Pan Head Screws (#24), eight Arc Washers(#29) and
four M8 Lock Nuts (#33).
NOTE: Do Not Tighten all the nuts and bolts at this time.
Right Angle
6
Left Angle
ASSEMBLY INSTRUCTIONS
Step 4
Attach the Right Dip Support (#7) to the Upper and Lower Upright Post (#4,#5),
align the holes and secure them with two M10 Hexagon Pan Head
Screws (#23), four Arc Washers(#28) and two M10 Lock Nuts (#32).
Repeat the same procedure to install the Left Dip Support (#6).
Attach the two Arm Pads (#12) onto the Left and Right Dip Supports (#6,#7),
secure each Arm Pad with two Arc Washers(#29), two M8x65 Hexagon Pan
Head Screws (#24).
NOTE: Do Not Tighten all the nuts and bolts at this time.
7
ASSEMBLY INSTRUCTIONS
Step5
Attach the Backrest Pad(#11) to the Cross Brace (#10). Secure it with
three Washers(#30) and three M8 Hexagon Pan Head
Screws (#25).
Attach the Chin-up Bar (#9) to the top opening on the two Upper Upright
Posts(#5), secure the Chin-up Bar to each opening with one Arc
Washer(#29) and one M8x40 Hexagon Pan Head (#25)
Cover each opening with an Upper Upright Post End Cap (#20).
NOTE: Securely tighten all Nuts and Bolts previously installed.
8
Final Assembly
9
CAUTION:
MAKE SURE ALL NUTS, BOLTS
& SCREWS ARE
COMPLETELY TIGHTENED
BEFORE USE
250 lbs Weight
Capacity
The End Caps can rotate to prevent wobbling.
If necessary adjust the floors caps height in
order to stabilize the unit on the floor.
PRECAUTIONS
WARNING: 250 LB WEIGHT CAPACITY-
To reduce the risk of serious injury, read all important precautions instructions
and warnings in this manual before using this product. Elite Fitness, or Extreme
Products Group assumes no responsibility for personal injury or property
damage sustained by or through the use of this Power Tower.
DO NOT USE ANY EXERCISE PRODUCTS WITHOUT A PHYSICIAN’S APPROVAL.
DO NOT LET CHILDREN USE THIS PRODUCT WITHOUT PROPER ADULT
SUPERVISION
KEEP YOUR FINGERS, BODY PARTS, CHILDREN AND PETS AWAY FROM
MOVING PARTS
WARM UP BEFORE EACH WORKOUT AND COOL DOWN AFTER EACH
WORKOUT
INSURE THAT ALL NUTS, BOLTS, AND SCREWS ARE COMPLETELY TIGHTENED
BEFORE USING THIS PRODUCT.
INSPECT THIS PRODUCT FOR TEARS AND BROKEN WELDS AND MAKE SURE
10
INSPECT THIS PRODUCT FOR TEARS AND BROKEN WELDS AND MAKE SURE
TO DO ROUTINE MAINTENANCE AND TIGHTENING OF ALL PARTS BEFORE
EACH WORKOUT.
IF ANY PARTS APPEAR WORN, OR BROKEN, OR IF THIS PRODUCT IS NOT
WORKING PROPERLY, DO NOT USE .
THIS PRODUCT IS FOR CONSUMER USE ONLY AND IS NOT MEANT FOR
COMMERCIAL USE.
KEEP PRODUCT INDOORS AWAY FROM MOISTURE AND DUST. PLACE THE
POWER TOWER ON LEVEL SURFACE WITH A MAT BENEATH IT TO PROTECT
THE FLOOR OR CARPET.
USE SLOW MOVEMENTS AND DO NOT BOUNCE UP AND DOWN ON THIS UNIT
FOR USE BY ONE PERSON AT ONE TIME
HAVING A PARTNER PRESENT DURING WORKOUTS IS RECOMMENDED TO
AVOID INJURY, AND ADDITIONAL SAFETY.
ELITE FITNESS
11
Distributed by:
Extreme Products Group
6635 W. Happy Valley Road
Suite A-104, # 213
Glendale, AZ 85310
Phone: 623-888-6379
Fax: 623-434-9100
Service@extremeproductsgroup.com
For all parts requests, please visit our website at:
www.extremeproductsgroup.com
/
