ESI SPACERKIT-KBD Owner's manual

ESI
Brand
ESI
Model
SPACERKIT-KBD
Category
Wall & ceiling mounts accessories
Type
Owner's manual

This manual is also suitable for

INSTALLATION
KEYBOARD TRACK
SPACER KIT Model SPACERKIT-KBD-V2
SPACERKIT-KBD-V2 Rev B 1/17
Front Track Bracket (1)
6mm Spacer (6)
M5x25mm(6) M5x30mm (2)M5x40mm (6)M5x50mm (6)
M6x16mm (6)
10mm Spacer (6) 20mm Spacer (8)
M5 Serrated
Flange Nut (8)
Rear Track Bracket (2)
800.833.3746esiergo.com
© 2017 ESI Ergonomic Solutions. All rights reserved. SPACERKIT-KBD-V2 Rev B 1/17
KEYBOARD TRACK SPACER KIT KEYBOARD TRACK SPACER KIT
PLEASE REVIEW these instructions before beginning the installation. Check
that all the parts shown on the cover were provided with your order. Contact
your supplier if any materials are missing. Do not discard the packaging until
satised that the product operates to your satisfaction.
Step 1
Determine which spacers and machine screws to assemble.
• Measure the height of the cross channel or other obstruction that needs to
be cleared.
• Choose the spacer/screw combination for the proper amount of clearance.
Step 2
Assemble the spacers and brackets to the keyboard track. See the illustration
at the top of the next page.
• In this example, an additional clearance of 2" (53mm) is added.
• Install 20mm spacers at the rear on the track for bumper spacer mounts. Use
an M5x30mm screw. Do not install the front bumper until after loading the
tray onto the track.
• Secure all screws with the M5 serrated ange nuts.
Step 3
Attach the track/spacer assembly to the underside of the work surface using
the six M6x16mm wood screws. See the illustration at the bottom of the next
page.
• Attach the wood screws through the mounting holes
in the brackets.
CAUTION: Always check that screws used to attach
components to the work surface are not too long for
the thickness of the surface.
6mm
Spacer
M5x25mm
Work Surface
10mm
Spacer
1.3"
(35mm)
2"
(53mm)
2.3"
(60mm)
20mm
Spacer
M5x40mm
M5x50mm
Cross
Channel
or Other
Obstruction
Measure
Work
Surface
Step 2 Illustration
Step 3 Illustration
Screw into
Bottom of
Work Surface
Install
Bumper
After
Loading Tray
Total of Six
M6x16mm
Screws
Required
Track Not
Included
Front Bumper
Spacer Mount
(Install After
Loading Tray)
Rear Bumper
Spacer Mount
Total of 8
Serrated Flange
Nuts Required
30mm
20mm
Front
Rear
  • Page 1 1
  • Page 2 2

ESI SPACERKIT-KBD Owner's manual

ESI
Brand
ESI
Model
SPACERKIT-KBD
Category
Wall & ceiling mounts accessories
Type
Owner's manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents