SCE SCE-PH5 Installation Information

Type
Installation Information
spec-handle-small-instman.pdf.pdf
1
Padlock Door Handle With Small Door Rod Kit
Insert stop pin here
Handle turns counter clockwise
Insert stop pin here
Handle turns clockwise
Small Rod Kit - SCE-103370
Small door rod kit for 2 or 3 point latching
Cutout Detail
Installation of SCE door hardware on enclosures
that do not have handles, or provisions for handles.
1. Locate and drill handle and rod guide
mounting holes.
2. Install rod guides.
3. Measure door opening height.
• Door rod length =
(door opening height/2) – 2.125”
• Door rod assembly length =
(door opening height/2) + 2.33”
4. Install door handle and latch (cam).
5. Insert door rod through the rod guide before
assembling the ramp shoes.
6. Install ramp shoes to the door rods and then
attach door rods to the latch plate.
3.250
I.D. door
2.250
I.D. door
Ø.886
.792
Ø.250
C
L
1.090
1.250 I.D.
door opening
small cam
See note 3 to
explain rod
Cutout detail
Door Interior View
spec-handle-small-instman.pdf.pdf
2
Recommended Handles
-SCE-PH5 (5.00 padlockable handle)
-SCE-PCH5 (5.00 padlockable slotted coin proof handle)
-SCE-PCH5-7SC (5.00 padlockable 7mm square coin proof handle)
-SCE-PKH5 (5.00 padlockable key locking handle)
-SCE-PH7 (7.00 padlockable handle)
-SCE-PCH7 (7.00 padlockable slotted coin proof handle)
-SCE-PCH7-7SC (7.00 padlockable 7mm square coin proof handle)
-SCE-PKH7 (7.00 padlockable key locking handle)
¼ -20 x ½ arc stud
or drill Ø0.25 for
¼ -20 fastener and
sealing washer Set screw
Flange nut
Flange bolt
Small Dual Cam
Can be used for both doors
hinged on left or right
Door rod guide
Door rod adapter
Set screw
Door handle cam
Door rod guide
Ramp shoe
2.50 x .625
aluminum flat bar
  • Page 1 1
  • Page 2 2

SCE SCE-PH5 Installation Information

Type
Installation Information

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI