2. Workrite Ergonomics
  3. TravelRite™ Portable Laptop Station

Workrite Ergonomics TravelRite™ Portable Laptop Station User guide

  • I've reviewed the user guide for the Workrite Palm Support UB2400-25J. This document details how to adjust the palm support height and tilt using included screws and spacers. The guide also provides clear instructions on how to lock the tilt adjustment tube.
  • How many height settings are available for the palm support?
    How is the tilt adjustment tube locked?
    Is any assembly required for TravelRite?
1 of 1 Workrite Ergonomics | (800) 959–9675 www.workriteergo.com
#1500033 Rev B
C #10-32 × ¾" Flat Head
Machine Screw
Qty: 2 D #10-32 × 1" Flat Head
Machine Screw
Qty: 2
Note: The TravelRite ships fully assembled.
Set Palm Support Height
Palm support height can be set at four dierent heights by
adding or removing spacers as needed.
¾" height with no spacers using #10-32 × ⅝" Screws (B).
1" height with one spacer using #10-32 × ¾" Screws (C).
1¼" height with two spacers using #10-32 × 1" Screws (D).
1½" height with three spacers using #10-32 × 1" Screws (D).
Palm Support is shipped with all three spacers in place at the
1½" height.
Adjust Tilt
Slide the acrylic Tilt Adjustment Tube forward and
back to achieve the desired tilt.
Close & Lock
Slide the Tilt Adjustment Tube
to the center of the Glide Slot
and rotate until it will slip
through the opening in the top
surface (approx. 45°.)
Pull up on the tube and slide
until it rests against the Palm
Support to lock closed.
A TravelRite
Qty: 1 B #10-32 × ⅝" Flat Head
Machine Screw
Qty: 2
Included
User Guide
TravelRite, UB2400-25J
Pull up
Palm Support
Top view
Side view
Rotate
Spacers (3)
Tilt Adjustment Tube
Tilt Adjustment Tube
BCD
A
3
a
a
b
b
1
2
Slide
Glide Slot
center
Opening
Slide
/