Dometic Duo Therm 41001. Cool Cat Heat Pump Air Conditioner_After Market Installation Supplement Installation guide
- Type
- Installation guide
REVISION
3107933.016 6/03
(Replaces 3107933.008)
©2003 Dometic Corporation
LaGrange , IN 46761
After Market Installation Supplement
Before starting installation, read and understand complete Installation and Operating Instructions
received with 41001.(XXX) Cool Cat Heat Pump Air Conditioner.
1. For after market installation a 22.75" wide by 15" high hole must be cut through the outside wall of the RV.
2. The interior cabinet space must be at least 20" deep for the Cool Cat Heat Pump Air Conditioner to fit and operate as
designed.
3. Cabinet space should be provided where the heat pump air conditioner will fit and provide good airflow to both the front and
rear of the RV.
4. A 115 volt a/c 20 amp circuit must be provided to operate the heat pump air conditioner unit. This circuit must be protected
by a 20 amp breaker or a 20 amp time delay fuse.
5. Before starting the installation, items that must be checked are:
A. Electrical wires in the wall
B. Water lines
C. LP gas line
6. Required tools for installation:
A. Jigsaw
B. Drill and drill bits
C. Screw drivers: Phillips and slotted
D. Silicone sealant
E. Socket set
F. Utility knife
G. Measuring tape
7. An inside cabinet front opening 20" wide by 15" high is required for supply and return air. When the outside wall hole has
been cut, finish the hole by using 1" of material cut to fit the outside wall opening.
A. Install the two-drain fittings using sealant to seal the fitting to the basepan.
B. Slide the heat pump air conditioner into the prepared opening.
C. Install the rain shield.
NOTE: The rain shield must have sealant applied to the short flange surfaces to seal out rainwater.
D. Seal along the heat pump air conditioner bottom to rain shield.
E. Install the hold down clamps.
F. Install the plastic tubes on the drain fittings.
G. Install the outside grille. The drain tubes should extend through the grille frame holes.
The outside work is complete.
If your cabinet space is 20"-23.5" deep, the metal duct extension is not needed.
Attach the registers to the heat pump unit knock out openings. In some installations
the register will need to be cut to fit the cabinet space.
After the register has been installed, install the inside grille to the
cabinet front.
See drawing for the order of installation
and installation kit component parts list.
For all wiring refer to the Installation
and Operating Instructions.
-
1
Dometic Duo Therm 41001. Cool Cat Heat Pump Air Conditioner_After Market Installation Supplement Installation guide
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
GE 4100 User manual
-
GE AZ65H15DAC Owner's manual
-
GE Zoneline Packaged Terminal Air Conditioners User manual
-
GE AZ39H07DAB Owner's manual
-
GE AZ38H07EAB Owner's manual
-
GE RAG61 Get installation instructions
-
GE Monogram 3900 series User manual
-
GE AZ41E15EAC Owner's manual
-
GE AZ35H12D3C Owner's manual
-
LG NHXM50S2A2.AMBALAP Installation guide
